Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU) › 2015.06–2017.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0261016 PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU) Y

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the intuitive parking assist system.

·

*: Use the Techstream.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
a.

Ask the customer about the problems and the conditions at the time the malfunction occurred to make sure the problem symptom was not temporarily caused by radio waves in the surrounding environment.

HINT:

The parking assist monitor display may be temporarily distorted due to radio waves around the vehicle.


Problem Symptom Cause
Both of the following conditions are met:
·

The problem symptom indicates a parking assist monitor display malfunction and the problem symptom cannot be reproduced.

·

DTC C1622 is output as "Hist"only.*


The display may be temporarily distorted when the vehicle is close to an object that transmits radio waves, such as a telecommunication tower, an airport or a truck equipped with a transceiver.


Result:
Proceed to
NEXT



NEXT

3.INSPECT BATTERY VOLTAGE
3.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage with the ignition switch off.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.


Result:
Proceed to
NEXT



NEXT

4.CHECK AUDIO AND VISUAL SYSTEM OR NAVIGATION SYSTEM
4.CHECK AUDIO AND VISUAL SYSTEM OR NAVIGATION SYSTEM


Result:
Result Proceed to
Audio and visual system and navigation system are normal A
Audio and visual system is abnormal (for Radio and Display Type) B
Navigation system is abnormal (for Navigation Receiver Type) C



A

5.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

B

C

5.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
a.

Use the GTS to check if the CAN communication systemis functioning normally.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD with Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING


Result:
Result Proceed to
CAN communication system DTCs are not output A
CAN communication system DTCs are output B



A

6.CHECK FOR DTC*

B

6.CHECK FOR DTC*


c.

Check for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>DTC CHECK / CLEAR


Result:
Result Proceed to
No DTCs are output A
DTCs are output B



A

7.PROBLEM SYMPTOMS TABLE

B

9.ADJUST, REPAIR OR REPLACE
7.PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B



A

8.OVERALL ANALYSIS AND TROUBLESHOOTING

B

9.ADJUST, REPAIR OR REPLACE
9.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

10.CONFIRMATION TEST
10.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END