The radio and display receiver assembly and map light assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines.
This DTC is stored when a microphone connection detection signal line is disconnected.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1579 | Telephone microphone signal is lost. | ·
Radio and display receiver assembly ·
Map light assembly ·
Telephone microphone assembly ·
Telematics transceiver* ·
Harness or connector |
*: w/ Telematics Transceiver
When replacing telematics transceiver, perform the vehicle contract setting.
Choose the model to be inspected.
| Model | Proceed to |
|---|---|
| w/o Telematics Transceiver | A |
| w/ Telematics Transceiver | B |
A
B
Disconnect the H51 radio and display receiver assembly connector.
Disconnect the W7 map light assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H51-5 (MIN+) - W7-12 (MCO+) | Always | Below 1 Ω |
| H51-4 (MACC) - W7-11 (MACC) | Always | Below 1 Ω |
| H51-19 (MIN-) - W7-13 (MCO-) | Always | Below 1 Ω |
| H51-6 (SNS2) - W7-14 (SNS2) | Always | Below 1 Ω |
| H51-5 (MIN+) - Body ground | Always | 10 kΩ or higher |
| H51-18 (SGND) - Body ground | Always | 10 kΩ or higher |
| H51-4 (MACC) - Body ground | Always | 10 kΩ or higher |
| H51-19 (MIN-) - Body ground | Always | 10 kΩ or higher |
| H51-6 (SNS2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the map light assembly.
Click hereVehicle Interior>LIGHTING (INT)>ROOM LIGHT(for Front)>REMOVAL
Remove the telephone microphone assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE AMPLIFIER>REMOVAL
| *a | Component without harness connected
(Map Light Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-11 (MACC) - B-5 (MACC) | Always | Below 1 Ω |
| A-12 (MCO+) - B-3 (MIC+) | Always | Below 1 Ω |
| A-13 (MCO-) - B-2 (MIC-) | Always | Below 1 Ω |
| A-14 (SNS2) - B-1 (SNS2) | Always | Below 1 Ω |
| A-11 (MACC) - A-12 (MCO+) | Always | 10 kΩ or higher |
| A-11 (MACC) - A-13 (MCO-) | Always | 10 kΩ or higher |
| A-11 (MACC) - A-14 (SNS2) | Always | 10 kΩ or higher |
| A-12 (MCO+) - A-13 (MCO-) | Always | 10 kΩ or higher |
| A-12 (MCO+) - A-14 (SNS2) | Always | 10 kΩ or higher |
| A-13 (MCO-) - A-14 (SNS2) | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the telephone microphone assembly with a new known good one.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE AMPLIFIER>REMOVAL
Check if the same DTC is output again.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL
Disconnect the H51 radio and display receiver assembly connector.
Disconnect the W7 map light assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H51-6 (SNS2) - W7-14 (SNS2) | Always | Below 1 Ω |
| H51-6 (SNS2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H51 radio and display receiver assembly connector.
Disconnect the G187 telematics transceiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H51-5 (MIN+) - G187-18 (MCO+) | Always | Below 1 Ω |
| H51-19 (MIN-) - G187-19 (MCO-) | Always | Below 1 Ω |
| H51-5 (MIN+) - Body ground | Always | 10 kΩ or higher |
| H51-19 (MIN-) - Body ground | Always | 10 kΩ or higher |
| H51-18 (SGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G187 telematics transceiver connector.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL
Disconnect the W7 map light assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G187-33 (MCVD) - W7-11 (MACC) | Always | Below 1 Ω |
| G187-34 (MCI+) - W7-12 (MCO+) | Always | Below 1 Ω |
| G187-35 (MCI-) - W7-13 (MCO-) | Always | Below 1 Ω |
| G187-33 (MCVD) - Body ground | Always | 10 kΩ or higher |
| G187-34 (MCI+) - Body ground | Always | 10 kΩ or higher |
| G187-35 (MCI-) - Body ground | Always | 10 kΩ or higher |
| G187-32 (SGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the map light assembly.
Click hereVehicle Interior>LIGHTING (INT)>ROOM LIGHT(for Front)>REMOVAL
Remove the telephone microphone assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE AMPLIFIER>REMOVAL
| *a | Component without harness connected
(Map Light Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-11 (MACC) - B-5 (MACC) | Always | Below 1 Ω |
| A-12 (MCO+) - B-3 (MIC+) | Always | Below 1 Ω |
| A-13 (MCO-) - B-2 (MIC-) | Always | Below 1 Ω |
| A-14 (SNS2) - B-1 (SNS2) | Always | Below 1 Ω |
| A-11 (MACC) - A-12 (MCO+) | Always | 10 kΩ or higher |
| A-11 (MACC) - A-13 (MCO-) | Always | 10 kΩ or higher |
| A-11 (MACC) - A-14 (SNS2) | Always | 10 kΩ or higher |
| A-12 (MCO+) - A-13 (MCO-) | Always | 10 kΩ or higher |
| A-12 (MCO+) - A-14 (SNS2) | Always | 10 kΩ or higher |
| A-13 (MCO-) - A-14 (SNS2) | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the W7 map light assembly connector.
| *a | Component with harness connected
(Telematics Transceiver) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G187-33 (MCVD) - Body ground | Engine switch on (ACC) | 4 to 6 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G187-32 (SGND) - Body ground | Always | Below 1 Ω |
| G187-35 (MCI-) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the telephone microphone assembly with a new known good one.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE AMPLIFIER>REMOVAL
Check if the same DTC is output again.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL