This DTC is output when an open circuit is detected in the high-low transfer shift motor drive circuit.
| DTC No. | DTC Detection Condition
1.
Diagnosis Condition 2.
Malfunction Status 3.
Malfunction Time 4.
Other |
Trouble Area |
|---|---|---|
| P17A8 | 1.
When switching between high and low or during switching operation (high-low transfer shift motor operating) with ignition switch turned to ON 2.
Open circuit in the high-low transfer shift motor drive circuit 3.
0.03 seconds or more 4.
1 trip detection logic |
·
Wire harness and connector ·
4 wheel drive control ECU ·
Transfer shift actuator assembly |
Refer to DTC P17A9 (See page Drivetrain>VF4BM (TRANSFER / 4WD / AWD)>TRANSFER SYSTEM>P17A9).
Disconnect the G54 4 wheel drive control ECU connector.
Disconnect the C43 transfer shift actuator assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G54-2 (HM1) - C43-8 (HM1) | Always | Below 1 Ω |
| G54-6 (HM2) - C43-7 (HM2) | Always | Below 1 Ω |
OK
NG
Disconnect the C43 transfer shift actuator assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 8 (HM1) - 7 (HM2) | Always | 1.5 to 100 Ω |
| *a | Component without harness connected
(Transfer Shift Actuator Assembly) |
OK
NG