Home › Vehicle Exterior › DOOR / HATCH › HOOD › from 2017.08
RM27T0E _59 Vehicle Exterior _053744 DOOR / HATCH _0261244 HOOD N

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

B212782C01
2.438,0.125 3.104,0.417 0.667,0.292 12 false *2 0.688,0.125 1.375,0.427 0.688,0.302 12 false *1
*1 Centering Bolt
*2 Standard Bolt


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

·

The specified torque for standard bolts is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 53292A 1.REMOVE UPPER RADIATOR SUPPORT SEAL

Hide 53111 2.REMOVE RADIATOR GRILLE

Hide 3.INSPECT HOOD SUB-ASSEMBLY

Hide 4.ADJUST HOOD SUB-ASSEMBLY

a.

Adjust the hood position.

i.
B238464

Loosen the 4 hinge bolts on the hood.


ii.

Move the hood and adjust the clearance between the hood and front fender.


iii.

Tighten the 4 hinge bolts on the hood.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)



b.

Adjust the height of the front end of the hood using the cushion rubbers.

i.
B487083

Adjust the 2 cushion rubbers so that the heights of the hood and fender are aligned.

HINT:

Raise or lower the front end of the hood by turning the 2 cushion rubbers.




c.

Adjust the hood lock assembly.

i.
B487084

Loosen the 3 bolts.


ii.

Adjust the hood lock assembly and tighten the 3 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


iii.

Check that the striker can smoothly engage with the hood lock assembly.



Hide 53292A 6.INSTALL UPPER RADIATOR SUPPORT SEAL