When the outer mirror switch assembly mirror surface adjust switch (up/down/left/right) is operated, up/down/left/right signals are received by the main body ECU (multiplex network body ECU). The main body ECU (multiplex network body ECU) sends the received signals to the outer mirror control ECU assembly LH*1 and RH*2 via CAN communication. The outer mirror control ECU assembly LH*1 and RH*2 receives the remote mirror selection signal and up/down/left/right signals and operates the outer rear view mirror assembly LH*1 and RH*2 up/down/left/right based on the signals.
*1: for LHD
*2: for RHD
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this problem.
If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.
As the door control battery is installed between the vehicle battery and main body ECU (multiplex network body ECU), first perform the inspections in On-Vehicle Inspection to confirm that there are no malfunctions in the power source circuit for the main body ECU (multiplex network body ECU) before performing this troubleshooting procedure.*
*: w/ Door Control Battery
Using the GTS, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Mirror Selection SW (R) | Mirror select switch signal for RH mirror / OFF or ON | OFF: Mirror select switch neutral position (off)
ON: Mirror select switch R switch on |
- |
| Mirror Selection SW (L) | Mirror select switch signal for LH mirror / OFF or ON | OFF: Mirror select switch off
ON: Mirror select switch L switch on |
- |
| Mirror Position SW (R) | Mirror surface adjust switch signal (Right) / OFF or ON | OFF: Mirror select switch neutral position (off)
ON: Mirror surface adjust switch pressed right |
Check with the mirror select switch L or R switch on |
| Mirror Position SW (L) | Mirror surface adjust switch signal (Left) / OFF or ON | OFF: Mirror surface adjust switch not pressed left
ON: Mirror surface adjust switch pressed left |
Check with the mirror select switch L or R switch on |
| Mirror Position SW (Up) | Mirror surface adjust switch signal (Up) / OFF or ON | OFF: Mirror surface adjust switch not pressed up
ON: Mirror surface adjust switch pressed up |
Check with the mirror select switch L or R switch on |
| Mirror Position SW (Dwn) | Mirror surface adjust switch signal (Down) / OFF or ON | OFF: Mirror surface adjust switch not pressed down
ON: Mirror surface adjust switch pressed down |
Check with the mirror select switch L or R switch on |
The display is as specified in the normal condition column.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the outer rear view mirror assembly (driver side).
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>REMOVAL
Inspect the outer rear view mirror assembly (driver side).
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the outer mirror switch assembly.
Click hereVehicle Exterior>MIRROR (EXT)>OUTER MIRROR SWITCH>REMOVAL
Inspect the outer mirror switch assembly.
Click hereVehicle Exterior>MIRROR (EXT)>OUTER MIRROR SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G11*1 or G196*2 outer mirror switch assembly connector.
*1: for LHD
*2: for RHD
Disconnect the G217 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G11-13 (B) - G217-4 (MIRB) | Always | Below 1 Ω |
| G11-14 (MSW) - G217-5 (MIRS) | Always | Below 1 Ω |
| G11-12 (MSWR) - G217-6 (MIRE) | Always | Below 1 Ω |
| G11-13 (B) or G217-4 (MIRB) - Body ground | Always | 10 kΩ or higher |
| G11-14 (MSW) or G217-5 (MIRS) - Body ground | Always | 10 kΩ or higher |
| G11-12 (MSWR) or G217-6 (MIRE) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G196-15 (B) - G217-4 (MIRB) | Always | Below 1 Ω |
| G196-13 (MSW) - G217-5 (MIRS) | Always | Below 1 Ω |
| G196-12 (MSWR) - G217-6 (MIRE) | Always | Below 1 Ω |
| G196-15 (B) or G217-4 (MIRB) - Body ground | Always | 10 kΩ or higher |
| G196-13 (MSW) or G217-5 (MIRS) - Body ground | Always | 10 kΩ or higher |
| G196-12 (MSWR) or G217-6 (MIRE) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG