1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67920
3.REMOVE DOOR SCUFF PLATE ASSEMBLY LH (for LHD)
62112
4.REMOVE COWL SIDE TRIM BOARD LH (for LHD)
55318C
5.REMOVE INSTRUMENT SIDE PANEL LH (for LHD)
55471A
6.REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)
55606
7.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)
55476C
8.REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)
67910
9.REMOVE DOOR SCUFF PLATE ASSEMBLY RH (for RHD)
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL
62111C
10.REMOVE COWL SIDE TRIM BOARD RH (for RHD)
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL
55317A
11.REMOVE INSTRUMENT SIDE PANEL RH (for RHD)
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
55607
12.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)
55480D
13.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
55045
14.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
73900
15.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
89343C
16.REMOVE NO. 1 CLEARANCE WARNING BUZZER
for LHD:
Detach the clamp and remove the No. 1 clearance warning buzzer.
Disconnect the connector.
for RHD:
Detach the clamp and remove the No. 1 clearance warning buzzer.
Disconnect the connector.