Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › MULTI-TERRAIN MONITOR SYSTEM › 2017.08–2020.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0328431 MULTI-TERRAIN MONITOR SYSTEM C

PARK ASSIST / MONITORING  MULTI-TERRAIN MONITOR SYSTEM  C2A6B  Side Camera LH Response Malfunction  


DESCRIPTION

During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the side television camera assembly LH. This DTC is stored when the output of side television camera assembly LH does not match the expected output.

DTC Code DTC Detection Condition Trouble Area
C2A6B Abnormal response from the side television camera assembly LH
·

Side television camera assembly LH

·

Parking assist ECU



CAUTION / NOTICE / HINT

NOTICE:
·

When "!" mark is displayed on the navigation receiver assembly*1 or radio and display receiver assembly*2 after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

(See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>INITIALIZATION)

*1: for Navigation Receiver Type

*2: for Radio and Display Type


·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the multi-terrain monitor system may be needed (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



PROCEDURE

1.CHECK FOR DTC

OK

NG

2.REPLACE SIDE TELEVISION CAMERA ASSEMBLY LH
2.REPLACE SIDE TELEVISION CAMERA ASSEMBLY LH
a.

Replace the side television camera assembly LH with new or normally function one (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TELEVISION CAMERA (for Side)>REMOVAL).



NEXT

3.CHECK FOR DTC