Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU › 2017.08–2020.08
RM27T0E _57 Power Source / Network _053729 NETWORKING _0261035 NETWORK GATEWAY ECU A

NETWORKING  NETWORK GATEWAY ECU  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 89111 1.INSTALL NETWORK GATEWAY ECU

a.

Attach the 2 claws to install the network gateway ECU.


Hide 82878 2.INSTALL ECU INTEGRATION BOX LH (for RHD)

a.

Temporary set the ECU integration box LH to instrument panel reinforcement assembly.


b.

Install the ECU integration box LH with the 2 nuts and bolt.


c.

Attach the 2 clamps.


d.

Connect the 9 connectors.


Hide 82877 3.INSTALL ECU INTEGRATION BOX RH (for LHD)

a.

Temporary set the ECU integration box RH to instrument panel reinforcement assembly.


b.

Install the ECU integration box RH with the 2 nuts and bolt.


c.

Attach the 2 clamps.


d.

Connect the 9 connectors.


Hide 86740 4.INSTALL TELEPHONE TRANSCEIVER ASSEMBLY (for LHD, w/ Telematics Transceiver, w/o Double Door Lock)

Hide 86740 5.INSTALL TELEPHONE TRANSCEIVER ASSEMBLY WITH DOUBLE LOCK DOOR CONTROL RELAY ASSEMBLY (for LHD, w/ Telematics Transceiver, w/ Double Door Lock)

a.

Connect the 4 connectors.


b.

Install the telephone transceiver assembly with double lock door control relay assembly with the bolt and nut.

Torque:
Bolt : 12.5 N*m (127 kgf*cm, 9 ft.*lbf)
Nut : 5.5 N*m (56 kgf*cm, 49 in.*lbf)


Hide 85940 6.INSTALL WINDSHIELD WIPER RELAY ASSEMBLY (for LHD, Auto Wiper)

Hide 87201B 7.INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY

Hide 55550 8.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 55461A 9.INSTALL INSTRUMENT PANEL ORNAMENT

Hide 55317A 10.INSTALL INSTRUMENT SIDE PANEL RH

Hide 62311B 11.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

a.

Install the front door opening trim weatherstrip RH.


Hide 55607 12.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 62111C 13.INSTALL COWL SIDE TRIM BOARD RH

HINT:

Use the same procedure for the RH side and LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>INSTALLATION


Hide 67910 14.INSTALL DOOR SCUFF PLATE ASSEMBLY RH

HINT:

Use the same procedure for the RH side and LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>INSTALLATION


Hide 15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION