When the air conditioning amplifier assembly is turned on, a magnet clutch assembly ON signal is sent from the MGC terminal of the air conditioning amplifier assembly. Then, the A/C COMP relay turns on to operate the magnet clutch assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Remove the A/C COMP relay from the engine room No. 1 relay block, junction block.
Inspect the A/C COMP relay (See page Vehicle Interior>HEATING / AIR CONDITIONING>RELAY(for Magnet Clutch Control)>ON-VEHICLE INSPECTION).
NG
NG
except 5L-E:
Remove the cooler compressor assembly (for 1GR-FE) (See page Vehicle Interior>HEATING / AIR CONDITIONING>COMPRESSOR (for 1GR-FE)>REMOVAL).
Remove the cooler compressor assembly (for 1KD-FTV) (See page Vehicle Interior>HEATING / AIR CONDITIONING>COMPRESSOR(for 1KD-FTV)>REMOVAL).
Remove the cooler compressor assembly (for 2TR-FE) (See page Vehicle Interior>HEATING / AIR CONDITIONING>COMPRESSOR (for 2TR-FE)>REMOVAL).
Remove the cooler compressor assembly (for 1GD-FTV) (See page Vehicle Interior>HEATING / AIR CONDITIONING>COMPRESSOR (for 1GD-FTV)>REMOVAL).
Disconnect the A magnet clutch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (MG+) - A-1 | Always | Below 1 Ω |
| 3 (MG+) - Body ground | Always | 10 kΩ or higher |
for 5L-E:
Remove the cooler compressor assembly (See page Vehicle Interior>HEATING / AIR CONDITIONING>COMPRESSOR (for 5L-E)>REMOVAL).
Disconnect the A magnet clutch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (MG+) - A-1 | Always | Below 1 Ω |
| 1 (MG+) - Body ground | Always | 10 kΩ or higher |
*: Replace procedure:
NG
NG
except 5L-E:
Reconnect the A magnet clutch connector.
Apply battery voltage to the magnet clutch assembly and check the operation of the magnet clutch assembly.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 3 (MG+)
Battery negative (-) → Body ground |
Magnet clutch assembly operating sound can be heard, and magnetic clutch hub and rotor lock. |
for 5L-E:
Reconnect the A magnet clutch connector.
Apply battery voltage to the magnet clutch assembly and check the operation of the magnet clutch assembly.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 1 (MG+)
Battery negative (-) → Body ground |
Magnet clutch assembly operating sound can be heard, and magnetic clutch hub and rotor lock. |
*: Replace procedure:
OK
NG
Remove the A/C COMP relay from the engine room No. 1 relay block, junction block.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| A/C COMP relay terminal 1 - Body ground | Ignition switch ON | 11 to 14 V |
| A/C COMP relay terminal 5 - Body ground | Always | 11 to 14 V |
| *1 | A/C COMP Relay |
| *a | Component without relay installed
(Engine Room No. 1 Relay Block, Junction Block) |
OK
NG
Disconnect the G25 amplifier connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G25-20 (MGC) - Body ground | Ignition switch off | Below 1 V |
| G25-20 (MGC) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to Air Conditioning Amplifier Assembly) |
OK
NG
Remove the A/C COMP relay from the engine room No. 1 relay block, junction block.
Disconnect the C39*1 or C113*2 compressor connector.
*1: except 5L-E
*2: for 5L-E
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A/C COMP relay terminal 3 - C39-3 (MG+) | Always | Below 1 Ω |
| C39-3 (MG+) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A/C COMP relay terminal 3 - C113-1 (MG+) | Always | Below 1 Ω |
| C113-1 (MG+) - Body ground | Always | 10 kΩ or higher |
OK
NG