In some cases, wireless door lock control functions are normal but the hazard warning light and/or wireless door lock buzzer answer-back function(s)* does not operate. In such cases, hazard warning light and wireless door lock buzzer* signal outputs from the main body ECU (multiplex network body ECU) may be malfunctioning.
*: w/ Wireless Door Lock Buzzer Answer-back Function
The wireless door lock control system uses the CAN communication system. First, confirm that there is no malfunction in the CAN communication system. Refer to the How to Proceed with Troubleshooting procedure.
If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.
Check the customize status of answer-back function has been default setting.
| Result | Proceed to |
|---|---|
| The customize status of answer-back function has been default setting. | A |
| The customize status of answer-back function has not been default setting. | B |
A
B
Check the wireless door lock control function using the door control transmitter assembly.
| Result | Proceed to |
|---|---|
| Wireless door lock/unlock operates normally. | A |
| Wireless door lock/unlock operates normally. | B |
A
B
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| FL Door Lock Pos | Front LH side door lock position switch signal / UNLOCK or LOCK | UNLOCK: Front LH side door unlocked
LOCK: Front LH side door locked |
- |
| FR Door Lock Pos | Front RH side door lock position switch signal / UNLOCK or LOCK | UNLOCK: Front RH side door unlocked
LOCK: Front RH side door locked |
- |
| RL-Door Lock Pos SW* | Rear LH side door lock position switch signal / ON or OFF | ON: Rear LH side door unlocked
OFF: Rear LH side door locked |
- |
| RR-Door Lock Pos SW* | Rear RH side door lock position switch signal / ON or OFF | ON: Rear RH side door unlocked
OFF: Rear RH side door locked |
- |
| Back Door Lock Pos SW | Back door lock position switch status / ON or OFF | ON: Back door unlocked
OFF: Back door locked |
- |
*: for 5 Door
The GTS should display as shown in the table according to door lock operation.
| Result | Proceed to |
|---|---|
| OK | A |
| NG | B |
A
B
Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM (except 5L-E)>Door Unlock Detection Switch Circuit
Check the wireless answer-back operation using the door control transmitter assembly.
| Result | Proceed to |
|---|---|
| Only wireless door lock buzzer answer-back does not occur.* | A |
| Only hazard warning light answer-back does not occur. | B |
*: w/ Wireless Door Lock Buzzer Answer-back Function
A
B
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Wireless Buzzer | Wireless door lock buzzer | ON/OFF | - |
| Result | Proceed to |
|---|---|
| Wireless door lock buzzer does not turn on/off. | A |
| Wireless door lock buzzer turns on/off. | B |
A
B
Disconnect the A39 wireless door lock buzzer connector.
Remove the main body ECU (multiplex network body ECU) from the driver side junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Connect the driver side junction block assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A39-1 (B) - A-21 (BZR) | Always | Below 1 Ω |
| A39-2 (E) - Body ground | Always | Below 1 Ω |
| A39-1 (B) or A-21 (BZR) - Other terminals and body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
|---|---|
| OK | A |
| NG | B |
A
B
Disconnect the A39 wireless door lock buzzer connector.
Disconnect the 2M driver side junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A39-1 (B) - 2M-30 | Always | Below 1 Ω |
| A39-2 (E) - Body ground | Always | Below 1 Ω |
| A39-1 (B) or 2M-30 - Other terminals and body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
|---|---|
| OK | A |
| NG | B |
A
B
Temporarily replace the wireless door lock buzzer with a new one.
Click hereVehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK BUZZER>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Check the operation of the wireless answer-back function.
Wireless answer-back function operates normally.
| Result | Proceed to |
|---|---|
| OK | A |
| NG | B |
A
B
Check that the hazard warning light blinks when the hazard warning signal switch is pressed.
Hazard warning light signal is normally.
| Result | Proceed to |
|---|---|
| OK | A |
| NG | B |
A
B
for Halogen Headlight:
for LED Headlight:
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (for LED Headlight)>Hazard Warning Switch Circuit