Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type) › 2017.08–2020.08
RM27T0E _56 Audio / Visual / Telematics _053721 NAVIGATION / MULTI INFO DISPLAY _0260991 NAVIGATION SYSTEM(for Navigation Receiver Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Navigation Receiver Type)  Illumination Circuit  


DESCRIPTION

Power is supplied to the navigation receiver assembly and steering pad switch assembly illumination when the light control switch is in the tail or head position.

WIRING DIAGRAM

E377085E03
1.354,0.521 2.406,0.76 1.052,0.24 10 false from TAIL Relay 3.313,0.688 3.875,0.885 0.563,0.198 10 false PANEL 6.167,3.031 6.563,3.229 0.396,0.198 10 false ILL+ 6.156,6.042 6.604,6.281 0.448,0.24 10 false GND1 6.146,5.083 6.625,5.281 0.479,0.198 10 false SWG 5.76,3.021 6.24,3.219 0.479,0.198 10 false H54 5.802,2.813 6.281,3.01 0.479,0.198 10 false 10 5.76,5.083 6.24,5.281 0.479,0.198 10 false H56 5.813,4.844 6.292,5.042 0.479,0.198 10 false 23 5.76,6.031 6.24,6.229 0.479,0.198 10 false H54 5.823,5.792 6.302,5.99 0.479,0.198 10 false 7 5.885,6.615 7.094,7.021 1.208,0.406 10 false Navigation Receiver Assembly 4.094,3.021 4.656,3.219 0.563,0.198 10 false G208 4.198,2.792 4.76,2.99 0.563,0.198 10 false 13 4.094,5.083 4.656,5.281 0.563,0.198 10 false G208 4.25,4.875 4.813,5.073 0.563,0.198 10 false 3 2.813,3.021 3.375,3.219 0.563,0.198 10 false z16 2.844,5.094 3.406,5.292 0.563,0.198 10 false z16 2.917,4.896 3.104,5.083 0.188,0.188 10 false 8 2.885,2.813 3.073,3 0.188,0.188 10 false 5 3.448,2.875 3.844,3.073 0.396,0.198 10 false IL+2 3.469,4.969 3.865,5.167 0.396,0.198 10 false EAU 3.104,5.927 4.177,6.417 1.073,0.49 10 false Spiral Cable Sub-assembly 0.406,6.635 2.51,7.125 2.104,0.49 10 false Steering Pad Switch Assembly 0.969,6.156 1.813,6.375 0.844,0.219 10 false for RH Side 1,3.729 1.844,3.948 0.844,0.219 10 false for LH Side

CAUTION / NOTICE / HINT

CAUTION:

The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precautionary notice for the Supplemental Restraint System (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK ILLUMINATION
a.

Check if the illumination for the navigation receiver assembly, steering pad switch assembly, heater control switch or others (hazard switch, transmission control switch, etc.) come on when the light control switch is turned to the head or tail position.


Result
Result Proceed to
Illumination comes on for all components except steering pad switch assembly. A
Illumination comes on for all components except radio and display receiver assembly. B
No illumination comes on (radio and display receiver assembly, steering pad switch, hazard switch, heater control switch, etc.). C


A

2.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - BATTERY)

B

6.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)

C

2.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - BATTERY)
a.
E270420C39
1.469,0.219 1.885,0.479 0.417,0.26 2.073,1.51 2.469,1.865 true 2.531,1.792 2.917,1.979 0.385,0.188 10 false IL+2 1.51,0.26 1.896,0.448 0.385,0.188 10 false G208 0.135,0.125 0.521,0.313 0.385,0.188 10 false *a
*a Front view of wire harness connector
(to Spiral Cable Sub-assembly)


Disconnect the spiral cable sub-assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
G208-13 (IL+2) - Body ground Light control switch tail or head position 11 to 14 V




OK

3.INSPECT STEERING PAD SWITCH ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT STEERING PAD SWITCH ASSEMBLY
a.

Remove the steering pad switch assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>REMOVAL).


b.

Inspect the steering pad switch assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>INSPECTION).



OK

4.INSPECT SPIRAL CABLE SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

4.INSPECT SPIRAL CABLE SUB-ASSEMBLY
a.

Remove the spiral cable sub-assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL).


b.

Inspect the spiral cable sub-assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSPECTION).



OK

5.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY)

NG

REPLACE SPIRAL CABLE SUB-ASSEMBLY

5.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY)
a.

Disconnect the H56 navigation receiver assembly connector.


b.

Disconnect the G208 spiral cable sub-assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H56-23 (SWG) - G208-3 (EAU) Always Below 1 Ω
H56-23 (SWG) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
a.
E259248C39
1.51,0.396 1.896,0.594 0.385,0.198 2.333,1.75 2.167,1.75 2.167,1.75 2.073,1.344 true 1.542,1.365 1.323,1.729 1.323,1.729 1.167,1.729 true 0.146,0.115 0.458,0.271 0.313,0.156 10 false *a 1.573,0.417 2.125,0.635 0.552,0.219 10 false H54 2.406,1.667 2.958,1.885 0.552,0.219 10 false ILL+ 0.75,1.646 1.302,1.865 0.552,0.219 10 false GND1
*a Front view of wire harness connector
(to Navigation Receiver Assembly)


Disconnect the navigation receiver assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H54-7 (GND1) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
H54-10 (ILL+) - Body ground Light control switch in the tail or head position 11 to 14 V




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR