Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for LHD vehicles.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67910
2.REMOVE DOOR SCUFF PLATE ASSEMBLY RH
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL
62111C
3.REMOVE COWL SIDE TRIM BOARD RH
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL
55607
4.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
62311B
5.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
55317A
6.REMOVE INSTRUMENT SIDE PANEL RH
55461A
7.REMOVE INSTRUMENT PANEL ORNAMENT
55550
8.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
87201B
9.REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY
82877
10.REMOVE ECU INTEGRATION BOX RH (for LHD)
82878
11.REMOVE ECU INTEGRATION BOX LH (for RHD)
88150A
12.REMOVE DRIVING SUPPORT ECU ASSEMBLY
| *A | for LHD |
| *B | for RHD |
Detach the 3 claws and remove the driving support ECU assembly.