The No. 1 ultrasonic sensor (rear corner sensor LH) is installed on the rear bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor (rear corner sensor LH). If the No. 1 ultrasonic sensor (rear corner sensor LH) has an open circuit or other malfunction, it will not function normally.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1AE6 | A malfunction of the No. 1 ultrasonic sensor (rear corner sensor LH). | ·
No. 1 ultrasonic sensor (rear corner sensor LH) ·
Clearance warning ECU |
If the DTC is output after repairs, turn the ignition switch ON and turn the back sonar or clearance sonar switch assembly is on. Then clear the DTC (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ Multi-display)>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ Multi-display)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| No DTC is output | A |
| Only DTC C1AE6 is output | B |
| DTC C1AE6 and C1AED are output | C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C
Replace the No. 1 ultrasonic sensor (rear corner sensor LH) with a normally functioning sensor (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Rear)>REMOVAL).
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
NEXT
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ Multi-display)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| No DTC is output | A |
| DTC C1AE6 is output (for LHD) | B |
| DTC C1AE6 is output (for RHD) | C |
A
B
(See pageAudio / Visual / Telematics>PARK ASSIST / MONITORING>CLEARANCE WARNING ECU (for LHD)>REMOVAL)
C
(See pageAudio / Visual / Telematics>PARK ASSIST / MONITORING>CLEARANCE WARNING ECU (for RHD)>REMOVAL)