1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for 4 Sensor Type)
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67910
3.REMOVE DOOR SCUFF PLATE ASSEMBLY RH (for 4 Sensor Type)
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL
62111C
4.REMOVE COWL SIDE TRIM BOARD RH (for 4 Sensor Type)
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL
55317A
5.REMOVE INSTRUMENT SIDE PANEL RH (for 4 Sensor Type)
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
55476C
6.REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for 4 Sensor Type)
55480D
7.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for 4 Sensor Type)
55606
8.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for 4 Sensor Type)
55045
9.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for 4 Sensor Type)
73900
10.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for 4 Sensor Type)
82730A
11.REMOVE DRIVER SIDE JUNCTION BLOCK ASSEMBLY (for 4 Sensor Type)
except 5L-E:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
for 5L-E:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
89340A
12.REMOVE CLEARANCE WARNING ECU ASSEMBLY (for 4 Sensor Type)
Disconnect the connector.
Remove the bolt and clearance warning ECU assembly.
67920
13.REMOVE DOOR SCUFF PLATE ASSEMBLY LH (for 8 Sensor Type)
62112
14.REMOVE COWL SIDE TRIM BOARD LH (for 8 Sensor Type)
55318C
15.REMOVE INSTRUMENT SIDE PANEL LH (for 8 Sensor Type)
55461A
16.REMOVE INSTRUMENT PANEL ORNAMENT (for 8 Sensor Type)
55607
17.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for 8 Sensor Type)
55550
18.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for 8 Sensor Type)
89340A
19.REMOVE CLEARANCE WARNING ECU ASSEMBLY (for 8 Sensor Type)
Disconnect the connector.
Remove the 2 nuts and clearance warning ECU assembly.