This DTC is stored if the parking assist ECU judges as a result of its self check that a synchronization problem is occurring in the image signal sent from the passenger side television camera assembly to the parking assist ECU.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1684 | Side Camera Current Malfunction | ·
Harness or connector ·
Parking assist ECU ·
Side television camera assembly RH (for LHD) ·
Outer rear view mirror assembly RH (for LHD) ·
Side television camera assembly LH (for RHD) ·
Outer rear view mirror assembly LH (for RHD) |
for LHD
for RHD
When "!" mark is displayed on the navigation receiver assembly*1 or radio and display receiver assembly*2 after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>INITIALIZATION
*1: for Navigation Receiver Type
*2: for Radio and Display Type
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the multi-terrain monitor system may be needed.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
Clear the DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>DTC CHECK / CLEAR
DTC C1684 is not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for LHD) | B |
| NG (for RHD) | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
Disconnect the I7 parking assist ECU connector.
Disconnect the J11 outer rear view mirror assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I7-31 (SCB+) - J11-6 (DCB+) | Always | Below 1 Ω |
| I7-32 (SGND) - J11-7 (DGND) | Always | Below 1 Ω |
| I7-31 (SCB+) or J11-6 (DCB+) - Body ground | Always | 10 kΩ or higher |
| I7-32 (SGND) or J11-7 (DGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component with harness connected
(Parking Assist ECU) |
Disconnect the outer rear view mirror assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I7-32 (SGND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| I7-31 (SCB+) - I7-32 (SGND) | Engine switch on (ACC) | 5.5 to 7.05 V |
| I7-31 (SCB+) - I7-32 (SGND) | Engine switch off | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(to Side Television Camera Assembly RH) |
| *b | Component without harness connected
(to Outer Mirror Actuator Assembly RH) |
Disconnect the outer rear view mirror assembly RH connector.
Disconnect the side television camera assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-1 (SCB+) - J11-6 (DCB+) | Always | Below 1 Ω |
| A-5 (SGND) - J11-7 (DGND) | Always | Below 1 Ω |
| A-1 (SCB+) or J11-6 (DCB+) - Body ground | Always | 10 kΩ or higher |
| A-5 (SGND) or J11-7 (DGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the side television camera assembly RH with a new or normally functioning one.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TELEVISION CAMERA (for Side)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>DTC CHECK / CLEAR
DTC C1684 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the I7 parking assist ECU connector.
Disconnect the K11 outer rear view mirror assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I7-31 (SCB+) - K11-6 (SCB+) | Always | Below 1 Ω |
| I7-32 (SGND) - K11-7 (SGND) | Always | Below 1 Ω |
| I7-31 (SCB+) or K11-6 (SCB+) - Body ground | Always | 10 kΩ or higher |
| I7-32 (SGND) or K11-7 (SGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component with harness connected
(Parking Assist ECU) |
Disconnect the outer rear view mirror assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I7-32 (SGND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| I7-31 (SCB+) - I7-32 (SGND) | Engine switch on (ACC) | 5.5 to 7.05 V |
| I7-31 (SCB+) - I7-32 (SGND) | Engine switch off | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(to Side Television Camera Assembly LH) |
| *b | Component without harness connected
(to Outer Mirror Actuator Assembly LH) |
Disconnect the outer rear view mirror assembly LH connector.
Disconnect the side television camera assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B-1 (SCB+) - K11-6 (SCB+) | Always | Below 1 Ω |
| B-5 (SGND) - K11-7 (SGND) | Always | Below 1 Ω |
| B-1 (SCB+) or K11-6 (SCB+) - Body ground | Always | 10 kΩ or higher |
| B-5 (SGND) or K11-7 (SGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the side television camera assembly LH with a new or normally functioning one.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TELEVISION CAMERA (for Side)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>DTC CHECK / CLEAR
DTC C1684 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG