12601B
1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Urea SCR System)
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for Cold Area)
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
53292A
3.REMOVE UPPER RADIATOR SUPPORT SEAL
52129B
4.REMOVE FRONT BUMPER LOWER COVER
51405A
5.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
6.DRAIN ENGINE COOLANT
7.DRAIN ENGINE COOLANT (w/ Urea SCR System)
82123
8.REMOVE NO. 3 ENGINE WIRE (for Cold Area)
16571C
9.REMOVE NO. 1 RADIATOR HOSE
17342F
10.REMOVE NO. 2 INTERCOOLER AIR HOSE (w/o Urea SCR System)
16572D
11.REMOVE NO. 2 RADIATOR HOSE (w/o Urea SCR System)
17341K
12.REMOVE INTERCOOLER AIR HOSE (w/o Urea SCR System)
161B0
13.REMOVE ELECTRIC WATER PUMP ASSEMBLY (w/ Urea SCR System)
16640
14.REMOVE INTERCOOLER RESERVOIR ASSEMBLY (w/ Urea SCR System)
Detach the clamp.
Move the hose clip and disconnect the No. 4 sub radiator hose.
Do not apply excessive force to the No. 4 sub radiator hose.
Prepare a dish to collect any coolant that leaks.
Detach the clamp.
Remove the 3 bolts and intercooler reservoir assembly.
16553B
15.DISCONNECT NO. 3 SUB RADIATOR HOSE (w/ Urea SCR System)
Detach the clamp and disconnect the No. 3 sub radiator hose.
16470
16.REMOVE RADIATOR RESERVOIR ASSEMBLY
17.DISCONNECT OIL COOLER HOSE (for Automatic Transmission)
88359
18.REMOVE VISCOUS HEATER V BELT
16711
19.REMOVE FAN SHROUD
20.DISCONNECT HEATER WATER OUTLET HOSE
Remove the bolt.
Using pliers, grip the claws of the clip and slide the clip to disconnect the heater water outlet hose.
Do not apply excessive force to the heater water outlet hose.
Prepare a drain pan or cloth in case the coolant leaks.
21.DISCONNECT HEATER WATER INLET HOSE
Using pliers, grip the claws of the clip and slide the clip to disconnect the heater water inlet hose.
Do not apply excessive force to the heater water inlet hose.
Prepare a drain pan or cloth in case the coolant leaks.
87120G
22.REMOVE VISCOUS HEATER WITH MAGNET CLUTCH ASSEMBLY
Disconnect the viscous heater connector.
Remove the 2 bolts and viscous heater with magnet clutch assembly.