Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
86160L
1.INSTALL FRONT NO. 4 SPEAKER ASSEMBLY
Connect the connector.
Install the front No. 4 speaker assembly with the 2 screws.
Do not touch the cone of the speaker.
When installing the speaker to the instrument panel, be careful that the wires do not get caught between parts.
55421B
2.INSTALL UPPER INSTRUMENT CLUSTER FINISH PANEL
86140A
3.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY (for Radio and Display Type)
86160P
4.INSTALL FRONT NO. 2 SPEAKER ASSEMBLY
Connect the connector.
Install the front No. 2 speaker assembly with the 2 screws.
Do not touch the cone of the speaker.
When installing the speaker to the instrument panel, be careful that the wires do not get caught between parts.
55408F
5.INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
62212
6.INSTALL FRONT PILLAR GARNISH LH
74611F
7.INSTALL NO. 1 ASSIST GRIP
74616C
8.INSTALL FRONT NO. 1 ASSIST GRIP PLUG LH
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART