A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
89340A
1.INSTALL CLEARANCE WARNING ECU ASSEMBLY (for 4 Sensor Type)
Install the clearance warning ECU assembly with the bolt.
Connect the connector.
89340A
2.INSTALL CLEARANCE WARNING ECU ASSEMBLY (for 8 Sensor Type)
Install the clearance warning ECU assembly with the 2 nuts.
Connect the connector.
55550
3.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
55607
4.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55461A
5.INSTALL INSTRUMENT PANEL ORNAMENT
55317A
6.INSTALL INSTRUMENT SIDE PANEL RH
62111C
7.INSTALL COWL SIDE TRIM BOARD RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>INSTALLATION
67910
8.INSTALL DOOR SCUFF PLATE ASSEMBLY RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>INSTALLATION
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
11.CHECK SRS WARNING LIGHT