Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
45100
4.REMOVE STEERING WHEEL ASSEMBLY
Remove the steering wheel assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>REMOVAL).
45287
5.REMOVE LOWER STEERING COLUMN COVER
for Manual Tilt and Manual Telescopic Steering Column:
Remove the lower steering column cover (See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column)>REMOVAL).
for Power Tilt and Power Telescopic Steering Column:
Remove the lower steering column cover (See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column)>REMOVAL).
45286B
6.REMOVE UPPER STEERING COLUMN COVER
for Manual Tilt and Manual Telescopic Steering Column:
Remove the upper steering column cover (See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column)>REMOVAL).
for Power Tilt and Power Telescopic Steering Column:
Remove the upper steering column cover (See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column)>REMOVAL).
84306
7.REMOVE SPIRAL CABLE SUB-ASSEMBLY (w/o Steering Sensor)
Disconnect the connectors from the spiral cable sub-assembly.
When handling the airbag connector, take care not to damage the airbag wire harness.
Detach the 3 claws and remove the spiral cable sub-assembly.
84307
8.REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY (w/ Steering Sensor)
Disconnect the connectors from the spiral cable with sensor sub-assembly.
When handling the airbag connector, take care not to damage the airbag wire harness.
Detach the 3 claws and remove the spiral cable with sensor sub-assembly.
Do not replace the spiral cable with sensor sub-assembly when the ignition switch is ON and the battery cable is connected.
Do not rotate the spiral cable with sensor sub-assembly when the ignition switch is ON and the battery cable is connected.
Make sure the steering wheel assembly is installed and centered before rotating the steering sensor when performing steering sensor operation inspections (inspecting for abnormal noise, diagnosis inspections, etc.).
89245B
9.REMOVE STEERING SENSOR (w/ Steering Sensor)
Remove the steering sensor from the spiral cable sub-assembly only when replacing the spiral cable sub-assembly.
Removing the steering sensor from the spiral cable sub-assembly without using a lock pin may result in a misaligned center position of the steering sensor. Therefore, make sure to use the lock pin provided with a new spiral cable sub-assembly when removing the steering sensor from the spiral cable sub-assembly.
Install the lock pin to the steering sensor.
Use the lock pin provided with a new spiral cable sub-assembly.
Do not remove the lock pin before the spiral cable sub-assembly is installed to the steering sensor.
Remove the steering sensor.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>STEERING ANGLE SENSOR>REMOVAL