Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering wheel (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2. PRECAUTION
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
3. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
Disable the auto tilt away function by changing the customize parameter
Click hereSteering>STEERING COLUMN>POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM>CUSTOMIZE PARAMETERS
Record the current customize parameter setting (whether the auto tilt away function is enabled or disabled) in order to restore the current setting after finishing the operation.
Turn the ignition switch to ON. Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.
4.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
5.REMOVE FRONT WHEEL LH
45100
6.REMOVE STEERING WHEEL ASSEMBLY
45287
7.REMOVE STEERING COLUMN LOWER COVER
Remove the 3 screws.
Detach the 2 claws and remove the steering column lower cover.
Do not damage the tilt and telescopic switch.
45286B
8.REMOVE STEERING COLUMN UPPER COVER
Detach the 4 clips.
Detach the claw and remove the steering column upper cover.
89235A
9.REMOVE TILT AND TELESCOPIC SWITCH
10.REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
Disconnect the connectors from the combination switch with spiral cable.
Use pliers to hold the clamp and raise the claw with a screwdriver. Then remove the combination switch switch assembly with spiral cable sub-assembly from the steering column assembly.
55045
11.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (w/o Knee Airbag)
73900
12.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
45250
13.REMOVE STEERING COLUMN ASSEMBLY
Disconnect the connectors.
Detach the claws and remove the wire harness protector and wire harness.
Put matchmarks on the steering actuator and steering column.
| *a | Matchmark |
Remove the bolt.
Remove the 4 nuts, steering column and steering shaft stopper.
53736B
14.REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL RH
45220
15.DISCONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY
45025D
16.REMOVE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
45203
17.DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY