Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
67920
3.REMOVE DOOR SCUFF PLATE ASSEMBLY LH (for LHD)
67910
4.REMOVE DOOR SCUFF PLATE ASSEMBLY RH (for RHD)
62112
5.REMOVE COWL SIDE TRIM BOARD LH (for LHD)
62111C
6.REMOVE COWL SIDE TRIM BOARD RH (for RHD)
55606
7.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55318C
8.REMOVE INSTRUMENT SIDE PANEL LH (for LHD)
55317A
9.REMOVE INSTRUMENT SIDE PANEL RH (for RHD)
55471A
10.REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)
55476C
11.REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)
55480D
12.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
55045
13.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
73900
14.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Remove the 4 bolts and airbag assembly.
Disconnect the connector.
When handling the airbag connector, take care not to damage the airbag wire harness.