Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
85710E
1.INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Apply MP grease to the sliding and rotating areas of the regulator motor.
Using a T25 "TORX" socket wrench, install the rear power window regulator motor assmbly LH with the 3 screws.
A new rear power window regulator motor assmbly LH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
69840A
2.INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY LH
68104
3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
68124B
4.INSTALL REAR DOOR QUARTER WINDOW GLASS LH
67408E
5.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68152C
6.INSTALL REAR DOOR GLASS RUN LH
67842E
7.INSTALL REAR DOOR SERVICE HOLE COVER
86160C
8.INSTALL REAR SPEAKER SET
68174A
9.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH
67604
10.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
74611C
11.INSTALL ASSIST GRIP COVER LH
69298C
12.INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH
13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
14. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
15.INITIALIZE POWER WINDOW CONTROL SYSTEM
Initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).