1.ADJUST COMPRESSOR OIL
When replacing the compressor and magnet clutch with a new one, gradually discharge the refrigerant gas from the service valve and drain the following amount of oil from the new compressor and magnet clutch before installation.
for Single Air Conditioning System:
(The amount of oil inside a new cooler compressor: 120 to 135 cc (4.1 to 4.6 fl. oz.)) - (The amount of oil remaining in the removed cooler compressor) = (The amount of oil to be removed when replacing the compressor)
for Dual Air Conditioning System:
(The amount of oil inside a new cooler compressor: 180 to 195 cc (6.1 to 6.6 fl. oz.)) - (The amount of oil remaining in the removed cooler compressor) = (The amount of oil to be removed when replacing the compressor)
When checking the compressor oil level, follow the A/C system precautions.
Since compressor oil remains in the pipes of the vehicle, if a new compressor is installed without removing some oil from the compressor, the oil amount becomes excessive. Excessive oil prevents heat exchange in the refrigerant cycle and causes refrigeration system failure.
If the volume of oil remaining in the removed compressor and magnet clutch is small, check for oil leakage.
Be sure to use ND-OIL 8 or equivalent compressor oil.
88320
2.INSTALL COOLER COMPRESSOR ASSEMBLY
Install the compressor with the 4 bolts and tighten the bolts in the order shown in the illustration.
Connect the connector.
88704
3.INSTALL SUCTION HOSE SUB-ASSEMBLY
Remove the vinyl tape attached to the hose.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor.
ND-OIL 8 or equivalent
Install the O-ring to the suction hose.
Connect the suction hose with the bolt.
88703
4.INSTALL DISCHARGE HOSE SUB-ASSEMBLY
Remove the vinyl tape attached to the hose.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor.
ND-OIL 8 or equivalent
Install the O-ring to the discharge hose.
Connect the discharge hose with the bolt.
44320
5.CONNECT VANE PUMP ASSEMBLY
16711
6.INSTALL FAN SHROUD
16572D
7.INSTALL NO. 2 RADIATOR HOSE
16571C
8.INSTALL NO. 1 RADIATOR HOSE
16470
9.INSTALL RADIATOR RESERVOIR
16361A
10.INSTALL FAN AND GENERATOR V BELT
51405A
11.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
52129B
12.INSTALL FRONT BUMPER COVER LOWER
13.CHARGE REFRIGERANT
14.ADD ENGINE COOLANT
15.WARM UP ENGINE
16.CHECK FOR REFRIGERANT LEAK
53292A
17.INSTALL UPPER RADIATOR SUPPORT SEAL