For more information on the differential pressure sensor and Diesel Particulate Filter (DPF), refer to the following procedures.
Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Urea SCR System)>SYSTEM DESCRIPTION
If P24521C is present, refer to the DTC chart for DPF system.
Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Urea SCR System)>SYSTEM DESCRIPTION
If the air hoses of the differential pressure sensor are incorrectly connected (crossed), the ECM interprets this as an abnormal pressure difference, DTC P24521C (Particulate Filter Pressure Sensor "A" Circuit Voltage Out of Range) is stored and the MIL illuminates.
Refer to DTC P245211.
Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Urea SCR System)>P245211
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P24521C | Particulate Filter Pressure Sensor "A" Circuit Voltage Out of Range | When the output voltage from the differential pressure sensor indicates a reversal of positive and negative pressure.
(1 trip detection logic) |
·
Incorrect air hose routing ·
Air hose is clogged ·
Blockage in vacuum pipe ·
Differential pressure sensor ·
ECM |
Comes on | DTC stored | SAE Code: P2453 |
| DTC No. | Data List |
|---|---|
| P24521C | Particulate Filter Differential Pressure Bank 1 |
DTC P245211 (Particulate Filter Pressure Sensor "A" Circuit Short to Ground) and/or DTC P245215 (Particulate Filter Pressure Sensor "A" Circuit Short to Battery or Open) will be stored if there is an open or short malfunction in the differential pressure sensor circuit.
After confirming DTC P24521C, check the differential pressure in "Powertrain / Engine / Data List / Diesel Exhaust / Particulate Filter Differential Pressure Bank 1" using the GTS.
| Condition | Particulate Filter Differential Pressure Bank 1 Output | Sensor Condition |
|---|---|---|
| Engine switch on (IG) | Approximately 0 kPa | Normal |
| Always | -5 kPa or less or higher than 99 kPa | Open or short circuit |
| 4000 rpm (No engine load) | Negative output | Incorrect hose routing |
In order to detect abnormality in the differential pressure sensor, the ECM always monitors the output voltage from the sensor. When the sensor output voltage is a reversal of positive and negative pressure, the ECM interprets this as an incorrect air hose arrangement of the sensor, or determines that the air hoses are clogged, and illuminates the MIL.
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P24521C | Engine is running at 4000 rpm with no load for 10 seconds or more |
After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Urea SCR System)>REGISTRATION) and initialization (Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Urea SCR System)>INITIALIZATION).
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P24521C is output | A |
| DTC P24521C and other DTCs are output | B |
If any DTCs other than P24521C are output, troubleshoot those DTCs first.
A
B
| *1 | Air Hose (Downstream) | *2 | Air Hose (Upstream) |
| *3 | No. 2 Vacuum Pipe | *4 | No. 1 Vacuum Pipe |
Check if the air hose routing between the differential pressure sensor and vacuum pipe is correct.
Check that there is no exhaust gas leakage between the differential pressure sensor and vacuum pipe.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Be careful of being burned by exhaust gases during the following inspection.
| *1 | Air Hose |
Disconnect the air hoses (both upstream and downstream) from the differential pressure sensor.
Start the engine.
Check if there are exhaust gas pulsations from both air hoses during idling.
Exhaust gas pulsation exists.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / Diesel Exhaust / Particulate Filter Differential Pressure Bank 1.
Check that the "Particulate Filter Differential Pressure Bank 1" is as specified below.
| Switch Condition | Particulate Filter Differential Pressure Bank 1 | Sensor Condition |
|---|---|---|
| Engine switch on (IG) | Approximately 0 kPa | Normal |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the differential pressure sensor.
Click hereEngine / Hybrid System>1GD-FTV (EMISSION CONTROL)>DIFFERENTIAL PRESSURE SENSOR>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Clear the DTCs.
Turn the engine switch off for 30 seconds or more.
Turn the engine switch on (IG) and turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / Diesel Exhaust / Particulate Filter Differential Pressure Bank 1.
Check that the differential pressure is as specified below.
As long as the pipe connections are correct, the displayed pressure will not be vacuum pressure.
For reference result of real-vehicle check is as shown in the table below:
| Condition | Particulate Filter Differential Pressure Bank 1 |
|---|---|
| 2500 rpm without load | 0.5 kPa or higher |
Start the engine.
Engine is running at 4000 rpm with no load for 10 seconds or more.
Confirm that the DTC is not output.
Perform the following procedure using the GTS to determine whether or not the DTC judgment has been carried out.
Enter the following menus: Powertrain / Engine / Utility / All Readiness.
Input DTC P24521C.
Check that STATUS is NORMAL. If STATUS is INCOMPLETE, run the engine at 4000 rpm with no load for 10 seconds or more.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT