Home › Vehicle Exterior › WINDOW / GLASS › WINDSHIELD DEICER SYSTEM › from 2020.08
RM27T0E _59 Vehicle Exterior _053742 WINDOW / GLASS _0261227 WINDSHIELD DEICER SYSTEM J

WINDOW / GLASS  WINDSHIELD DEICER SYSTEM  Windshield Deicer does not Operate  


DESCRIPTION

When the front wiper deicer switch is turned on, the front wiper deicer switch operation information is sent to the air conditioning amplifier assembly. When the air conditioning amplifier assembly receives the front wiper deicer switch operation information, it turns the front wiper deicer relay (DEICER) on and operates the windshield deicer system.

WIRING DIAGRAM

B243044E03
3.615,2.729 4.406,3.365 0.792,0.635 10 false Front Wiper Deicer Relay (DEICER) 3.615,4.865 4.021,5.031 0.406,0.167 10 false FDEF 2.604,4.854 3.063,5.063 0.458,0.208 10 false FDFI 1.958,4.854 2.365,5.021 0.406,0.167 10 false SW 1 1.99,4.594 2.281,4.74 0.292,0.146 10 false G24 2.625,4.594 2.927,4.74 0.302,0.146 10 false G24 3.667,4.594 3.958,4.74 0.292,0.146 10 false G25 0.104,2.615 0.594,2.823 0.49,0.208 10 false G219 6.021,1.365 6.594,1.531 0.573,0.167 10 false DEICER 1.573,0.938 2.521,1.104 0.948,0.167 10 false ECU-IG NO. 2 5.031,0.76 5.844,0.948 0.813,0.188 10 false from Battery 0.24,0.792 1.125,1.156 0.885,0.365 10 false from IG NO. 1 Relay 2.667,3.458 2.802,3.625 0.135,0.167 10 false D 2.635,2.292 2.813,2.458 0.177,0.167 10 false IG 2.063,3.458 2.188,3.625 0.125,0.167 10 false E 2.813,2.073 3.01,2.25 0.198,0.177 10 false 5 2.813,3.729 3.073,3.938 0.26,0.208 10 false 4 2.177,3.74 2.417,3.948 0.24,0.208 10 false 2 2.948,4.583 3.125,4.74 0.177,0.156 10 false 11 4.01,4.583 4.188,4.74 0.177,0.156 10 false 40 2.323,4.594 2.438,4.75 0.115,0.156 10 false 5 4.74,2.406 4.927,2.604 0.188,0.198 10 false 2 4.76,3.406 4.948,3.604 0.188,0.198 10 false 1 5.479,2.406 5.677,2.625 0.198,0.219 10 false 3 5.49,3.406 5.698,3.635 0.208,0.229 10 false 5 5.479,4.594 5.656,4.833 0.177,0.24 10 false 2 6.76,5.5 6.969,5.677 0.208,0.177 10 false 1 6.75,4.594 6.854,4.74 0.104,0.146 10 false 3 4.906,5.5 5.438,5.688 0.531,0.188 10 false A101 1.771,5.552 4.344,5.906 2.573,0.354 10 false Air Conditioning Amplifier Assembly 4.896,5.708 6.469,6.063 1.573,0.354 10 false Windshield Glass (Windshield Deicer Wire) 0.115,2.802 1.781,3.229 1.667,0.427 10 false Front Wiper Deicer Switch 5.365,4.865 5.552,5.073 0.188,0.208 10 false B 6.615,4.875 6.896,5.104 0.281,0.229 10 false B2 6.656,5.229 6.844,5.438 0.188,0.208 10 false E

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following procedure.

·

Troubleshoot the windshield deicer system after confirming that the air conditioning system is functioning properly.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>HOW TO PROCEED WITH TROUBLESHOOTING



PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (DEICER RELAY (FRONT))
a.

Using the GTS, perform the Active Test.

Click hereVehicle Exterior>WINDOW / GLASS>WINDSHIELD DEICER SYSTEM>DATA LIST / ACTIVE TEST

Air Conditioner
Tester Display Measurement Item Control Range Diagnostic Note
Deicer Relay (Front) Windshield glass (windshield deicer wire) OFF or ON -

OK:

The windshield deicer system operates normally.



Result:
Proceed to
OK
NG



OK

2.INSPECT FRONT WIPER DEICER SWITCH

NG

4.CHECK HARNESS AND CONNECTOR (WINDSHIELD GLASS [WINDSHIELD DEICER WIRE] - BATTERY)
2.INSPECT FRONT WIPER DEICER SWITCH
a.

Remove the front wiper deicer switch.

Click hereVehicle Exterior>WINDOW / GLASS>WINDSHIELD DEICER SWITCH>REMOVAL


b.

Inspect the front wiper deicer switch.

Click hereVehicle Exterior>WINDOW / GLASS>WINDSHIELD DEICER SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (FRONT WIPER DEICER SWITCH - AIR CONDITIONING AMPLIFIER ASSEMBLY)

NG

REPLACE FRONT WIPER DEICER SWITCH

3.CHECK HARNESS AND CONNECTOR (FRONT WIPER DEICER SWITCH - AIR CONDITIONING AMPLIFIER ASSEMBLY)
a.

Disconnect the G219 front wiper deicer switch connector.


b.

Disconnect the G24 air conditioning amplifier assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G219-2 (E) - G24-5 (SW 1) Always Below 1 Ω
G219-4 (D) - G24-11 (FDFI) Always Below 1 Ω
G219-2 (E) or G24-5 (SW 1) - Body ground Always 10 kΩ or higher
G219-4 (D) or G24-11 (FDFI) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (WINDSHIELD GLASS [WINDSHIELD DEICER WIRE] - BATTERY)
a.
B416366C05
1.51,0.146 1.885,0.417 0.375,0.271 0.979,1.688 1.479,1.271 true 1.938,1.5 2.594,1.708 true 0.208,0.229 0.521,0.427 0.313,0.198 10 false *a 1.542,0.198 1.969,0.365 0.427,0.167 10 false A101 0.76,1.667 0.917,1.865 0.156,0.198 10 false B 2.635,1.667 2.875,1.875 0.24,0.208 10 false B2
*a Front view of wire harness connector
(to Windshield Glass [Windshield Deicer Wire])


Disconnect the windshield glass (windshield deicer wire) connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
A101-2 (B) - Body ground Ignition switch ON, front wiper deicer switch off Below 1 V
Ignition switch ON, front wiper deicer switch on 11 to 14 V
A101-3 (B2) - Body ground Ignition switch ON, front wiper deicer switch off Below 1 V
Ignition switch ON, front wiper deicer switch on 11 to 14 V



Result:
Proceed to
OK
NG



OK

5.CHECK HARNESS AND CONNECTOR (WINDSHIELD GLASS [WINDSHIELD DEICER WIRE] - BODY GROUND)

NG

6.INSPECT FRONT WIPER DEICER RELAY (DEICER)
5.CHECK HARNESS AND CONNECTOR (WINDSHIELD GLASS [WINDSHIELD DEICER WIRE] - BODY GROUND)
a.
B416366C06
1.51,0.146 1.885,0.417 0.375,0.271 1.938,1.219 2.625,1.219 true 0.208,0.229 0.521,0.427 0.313,0.198 10 false *a 1.542,0.198 1.969,0.365 0.427,0.167 10 false A101 2.698,1.146 2.854,1.344 0.156,0.198 10 false E
*a Front view of wire harness connector
(to Windshield Glass [Windshield Deicer Wire])


Disconnect the windshield glass (windshield deicer wire) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A101-1 (E) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPLACE WINDSHIELD GLASS (WINDSHIELD DEICER WIRE)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.INSPECT FRONT WIPER DEICER RELAY (DEICER)
a.

Remove the front wiper deicer relay (DEICER) from the engine room relay block, junction block.


b.

Inspect the front wiper deicer relay (DEICER).

Click hereVehicle Exterior>WINDOW / GLASS>RELAY (for Windshield Deicer)>ON-VEHICLE INSPECTION


Result:
Proceed to
OK
NG



OK

7.CHECK HARNESS AND CONNECTOR (FRONT WIPER DEICER RELAY [DEICER] - BATTERY)

NG

REPLACE FRONT WIPER DEICER RELAY (DEICER)

7.CHECK HARNESS AND CONNECTOR (FRONT WIPER DEICER RELAY [DEICER] - BATTERY)
a.
B472073C02
0.156,0.115 0.469,0.313 0.313,0.198 10 false *a
*a Front view of wire harness connector
(to Front Wiper Deicer Relay [DEICER])


Remove the front wiper deicer relay (DEICER) from the engine room relay block, junction block.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
Front wiper deicer relay (DEICER) terminal 3 - Body ground Always 11 to 14 V
Front wiper deicer relay (DEICER) terminal 2 - Body ground Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

8.CHECK HARNESS AND CONNECTOR (FRONT WIPER DEICER RELAY [DEICER] - AIR CONDITIONING AMPLIFIER ASSEMBLY AND WINDSHIELD GLASS [WINDSHIELD DEICER WIRE])

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

8.CHECK HARNESS AND CONNECTOR (FRONT WIPER DEICER RELAY [DEICER] - AIR CONDITIONING AMPLIFIER ASSEMBLY AND WINDSHIELD GLASS [WINDSHIELD DEICER WIRE])
a.

Remove the front wiper deicer relay (DEICER) from the engine room relay block, junction block.


b.

Disconnect the A101 windshield glass (windshield deicer wire) connector.


c.

Disconnect the G25 air conditioning amplifier assembly connector.


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Front wiper deicer relay (DEICER) terminal 5 - A101-2 (B) Always Below 1 Ω
Front wiper deicer relay (DEICER) terminal 5 - A101-3 (B2) Always Below 1 Ω
Front wiper deicer relay (DEICER) terminal 1 - G25-40 (FDEF) Always Below 1 Ω
Front wiper deicer relay (DEICER) terminal 5 or A101-2 (B) - Body ground Always 10 kΩ or higher
Front wiper deicer relay (DEICER) terminal 5 or A101-3 (B2) - Body ground Always 10 kΩ or higher
Front wiper deicer relay (DEICER) terminal 1 or G25-40 (FDEF) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR