Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE › from 2020.08
RM27T0E _52 Drivetrain _053705 AXLE AND DIFFERENTIAL _0260856 STEERING KNUCKLE A

AXLE AND DIFFERENTIAL  STEERING KNUCKLE  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 43502C 4.REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH

a.

Remove the front axle hub (See page Drivetrain>AXLE AND DIFFERENTIAL>FRONT AXLE HUB>REMOVAL).


Hide 45047 5.DISCONNECT TIE ROD END SUB-ASSEMBLY LH

Hide 48626 6.DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH

F042737

a.

Remove the 2 bolts and disconnect the front lower ball joint attachment from the axle.


Hide 43212 7.REMOVE STEERING KNUCKLE LH

a.

Support the front suspension lower arm LH with a jack.


b.

Remove the clip and nut.


c.
F042736E07
1.927,0.76 2.719,0.167 false 2.76,0.063 3.135,0.26 0.375,0.198 10 false SST

Using SST, disconnect the upper ball joint from the steering knuckle.

SST
09628-62011  

NOTICE:

Do not the damage the ball joint dust cover.



d.

Remove the steering knuckle.