Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1GD-FTV) › from 2020.08
RM27T0E _55 Steering _053717 POWER ASSIST SYSTEMS _0260953 VANE PUMP(for 1GD-FTV) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1GD-FTV)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, do not overtighten it.

·

When installing the parts indicated by arrows, coat them with power steering fluid (See page Steering>POWER ASSIST SYSTEMS>VANE PUMP (for 1GD-FTV)>COMPONENTS).



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 12601B 3.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17342F 4.REMOVE NO. 2 INTERCOOLER AIR HOSE (w/o Urea SCR System)

Hide 17030 5.REMOVE AIR HOSE ASSEMBLY (w/ Urea SCR System)

Hide 16361A 6.REMOVE FAN AND GENERATOR V BELT

Hide 44348A 7.REMOVE NO. 1 OIL RESERVOIR TO PUMP HOSE

a.
C327748

Slide the clip and disconnect the No. 1 oil reservoir to pump hose.


Hide 44410 8.REMOVE PRESSURE FEED TUBE ASSEMBLY

a.
C327749

Disconnect the connector from the vane pump assembly.


b.
C327750

Remove the union bolt and pressure feed tube assembly from the vane pump assembly.


c.

Remove the gasket from the pressure feed tube assembly.


Hide 44320 9.REMOVE VANE PUMP ASSEMBLY

a.

Disconnect the connector from the vane pump assembly.


b.
C327751

Remove the 2 bolts and vane pump assembly.