Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING ECU › from 2020.08
RM27T0E _55 Steering _053717 POWER ASSIST SYSTEMS _0260950 POWER STEERING ECU A

POWER ASSIST SYSTEMS  POWER STEERING ECU  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 55607 5.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 89650 11.REMOVE POWER STEERING ECU ASSEMBLY

a.
C218276

Using a screwdriver, detach the 2 claws and remove the power steering ECU assembly.

HINT:

Tape the screwdriver tip before use.