Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column) › from 2020.08
RM27T0E _55 Steering _053718 STEERING COLUMN _0260958 STEERING COLUMN ASSEMBLY(for Power Tilt and Power Telescopic Steering Column) A

STEERING COLUMN  STEERING COLUMN ASSEMBLY(for Power Tilt and Power Telescopic Steering Column)  INSTALLATION  


PROCEDURE

Hide 53737A 4.INSTALL FRONT NO. 1 FENDER APRON TO FRAME SEAL LH

Hide 45250 5.INSTALL STEERING COLUMN ASSEMBLY

a.

Align the matchmarks on the steering intermediate shaft, steering shaft stopper and steering column.


b.

Install the steering column with the 4 nuts.

Torque:
26 N*m (265 kgf*cm, 19 ft.*lbf)


c.

Install the bolts.

Torque:
36 N*m (367 kgf*cm, 27 ft.*lbf)


d.

Attach the claws to install the wire harness protector and wire harness.


e.

Connect the connectors.


Hide 73900 6.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 55045 7.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 8.INSTALL COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

a.

Using pliers, grip the claws of the clamp and install the combination switch assembly with spiral cable sub-assembly to the steering column assembly with the clamp.


b.

Connect the connectors to the combination switch with spiral cable.


Hide 89235A 9.INSTALL TILT AND TELESCOPIC SWITCH

a.

Attach the claw to install the switch.


b.

Connect the switch connector.


Hide 45286B 10.INSTALL STEERING COLUMN UPPER COVER

a.

Attach the claw to install the steering column upper cover.


b.

Attach the 4 clips to install the steering column upper cover to the instrument cluster finish panel.


Hide 45287 11.INSTALL STEERING COLUMN LOWER COVER

a.

Attach the 2 claws to install the steering column lower cover.

NOTICE:

Do not damage the tilt and telescopic switch.



b.

Install the 3 screws.


Hide 45100 13.INSTALL STEERING WHEEL ASSEMBLY

Hide 14.INSTALL FRONT WHEEL LH

Hide 15.CHECK FRONT WHEELS FACING STRAIGHT AHEAD

Hide 16.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 17. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

a.

Reset the auto tilt away function setting to the previous condition by changing the customize parameter.

Click hereSteering>STEERING COLUMN>POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM>CUSTOMIZE PARAMETERS


Hide 18. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART