Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2020.08
RM27T0E _58 Vehicle Interior _053733 METER / GAUGE / DISPLAY _0261082 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Speedometer Malfunction  


DESCRIPTION

The meter CPU receives vehicle speed signals from the skid control ECU via the CAN communication system. The speed sensor detects the wheel speed and sends the appropriate signals to the skid control ECU. The skid control ECU supplies power to the vehicle speed sensor. The skid control ECU detects vehicle speed signals based on the pulses of the voltage.

WIRING DIAGRAM

E200122E03
1.273,2.651 2.400,2.824 1.127,0.173 10 Skid Control ECU 0.816,3.346 2.745,3.524 1.928,0.178 10 : CAN Communication Line 4.443,2.652 6.293,2.823 1.849,0.172 10 Combination Meter Assembly

CAUTION / NOTICE / HINT

NOTICE:

If the vehicle speed is outside the allowable range when tested, perform the on-vehicle inspection (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>OPERATION CHECK).


HINT:

Before starting the following inspection, check tire size and tire air pressure.


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if a CAN communication DTC is output.


ii.

w/o Central Gateway ECU (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/o Central Gateway ECU)>DIAGNOSIS SYSTEM).

Result
Result Proceed to
CAN communication DTC is not output. A
CAN communication DTC is output. (w/ Central Gateway ECU) B
CAN communication DTC is output. (w/o Central Gateway ECU) C




A

2.PERFORM ACTIVE TEST USING GTS (SPEED METER OPERATION)

B

C

2.PERFORM ACTIVE TEST USING GTS (SPEED METER OPERATION)
a.

Using the GTS, perform the Active Test (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Speed Meter Operation Speedometer
·

OFF, 0, 40, 80, 120, 160 or 200 (km/h) (for km/h)

·

OFF, 0, 40, 80 or , 120 (mph) (for mph)


There is a deviation in the values displayed on the speedometer display (Control range → Speedometer)
for km/h (except Australia):
·

40 → 41.7 to 46.2

·

80 → 83.4 to 88.4

·

120 → 125.1 to 130.6

·

160 → 166.2 to 173.2


for km/h (for Australia):
·

40 → 40.8 to 45.3

·

80 → 81.6 to 86.6

·

120 → 122.4 to 127.4

·

160 → 163.2 to 168.2


for mph:
·

40 → 42 to 44.5

·

80 → 83.1 to 87.1



OK:

Speedometer indication is normal.




OK

3.READ VALUE USING GTS (VEHICLE SPEED METER)

NG

REPLACE COMBINATION METER ASSEMBLY

3.READ VALUE USING GTS (VEHICLE SPEED METER)
a.

Using the GTS, read the Data List (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).

Combination Meter
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Vehicle Speed Meter Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost the same as actual vehicle speed -

OK:

Vehicle speed displayed on the GTS is almost the same as the actual vehicle speed measured using a speedometer tester (calibrated chassis dynamometer).




OK

REPLACE COMBINATION METER ASSEMBLY

NG

4.READ VALUE USING GTS (FR/FL/RR/RL WHEEL SPEED)
4.READ VALUE USING GTS (FR/FL/RR/RL WHEEL SPEED)
a.

Using the GTS, read the Data List (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).

ABS/VSC/TRC
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
FR Wheel Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost same as actual vehicle speed -
FL Wheel Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost same as actual vehicle speed -
RR Wheel Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost same as actual vehicle speed -
RL Wheel Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost same as actual vehicle speed -

OK:

Vehicle speed displayed on the GTS is almost the same as the actual vehicle speed measured using a speedometer tester (calibrated chassis dynamometer).


Result
Result Proceed to
OK A
NG (for Hydraulic Brake Booster) B
NG (for 2TR-FE, Vacuum Brake Booster) C
NG (for 5L-E, Vacuum Brake Booster) D



A

5.REPLACE SKID CONTROL ECU

B

C

D

5.REPLACE SKID CONTROL ECU
a.

Replace the skid control ECU with a new or normally functioning one.

i.

ii.



b.

Check that the operation of the speedometer returns to normal.

OK:

The operation of the speedometer returns to normal.




OK

END (SKID CONTROL ECU IS DEFECTIVE)

NG

REPLACE COMBINATION METER ASSEMBLY