Home › Engine / Hybrid System › 1GD-FTV (STARTING) › STARTER (for 2.0 kW Type) › from 2020.08
RM27T0E _51 Engine / Hybrid System _053695 1GD-FTV STARTING _0260742 STARTER(for 2.0 kW Type) A

1GD-FTV STARTING  STARTER(for 2.0 kW Type)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

w/ Urea SCR System:

i.

Temporarily install the starter assembly.

NOTICE:

Be careful not to drop the starter assembly.


HINT:

Tie the starter assembly with a string.




b.

w/o Urea SCR System:

i.

for Manual Transmission:

Install the starter assembly with the 2 bolts.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)


ii.
U169561E01
0.095,0.787 0.297,0.971 0.202,0.184 10 *a 0.539,0.772 0.741,0.956 0.202,0.184 10 *a 0.484,1.686 0.686,1.870 0.202,0.184 10 *b 0.918,0.933 1.120,1.116 0.202,0.184 10 *b 1.444,1.451 1.646,1.635 0.202,0.184 10 *c 2.003,1.333 2.205,1.517 0.202,0.184 10 *c 1.744,0.579 1.947,0.763 0.202,0.184 10 *c

for Manual Transmission:

Connect the clutch release cylinder assembly with the 4 bolts, 3 nuts and a new clip.

Torque:
for bolt A : 12 N*m (120 kgf*cm, 9 ft.*lbf)
for bolt B, nut : 19 N*m (194 kgf*cm, 14 ft.*lbf)

Text in Illustration
*a Bolt A
*b Bolt B
*c Nut


iii.

for Automatic Transmission:

Install the starter assembly with the 2 bolts and nut.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)


iv.

Connect the starter wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


v.

Connect the starter connector.


vi.

Close the terminal cap.



Hide 37140 3.INSTALL FRONT PROPELLER SHAFT ASSEMBLY

Hide 53737A 4.INSTALL FRONT NO. 1 FENDER APRON TO FRAME SEAL LH

a.

Install the front No. 1 fender apron to frame seal LH with the 5 clips.


Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 6. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART