Home › Engine / Hybrid System › 1GD-FTV (STARTING) › STARTER (for 2.7 kW Type) › from 2020.08
RM27T0E _51 Engine / Hybrid System _053695 1GD-FTV STARTING _0260743 STARTER(for 2.7 kW Type) A

1GD-FTV STARTING  STARTER(for 2.7 kW Type)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the starter assembly removal/installation are shown below.

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Correction of steering angle neutral point Multi-terrain monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane departure alert system Drive the vehicle straight ahead at 40 km/h (25 mph) or more for 10 seconds or more. (Click here)
Pre-collision system
Lighting system (EXT) (for LED Headlight)
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Vehicle stability control system (for Hydraulic brake booster) Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds. (Click here)


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 53737A 3.REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL LH

a.

Remove the 5 clips and front No. 1 fender apron to frame seal LH.


Hide 37140 4.REMOVE FRONT PROPELLER SHAFT ASSEMBLY

Hide 28100 6.REMOVE STARTER ASSEMBLY

a.

w/ Urea SCR System:

i.

Remove the starter assembly.



b.

w/o Urea SCR System:

i.
A351933

Open the terminal cap.


ii.

Remove the nut and disconnect the starter wire.


iii.

Disconnect the starter connector.


iv.
A343736

for Automatic Transmission:

Remove the bolt, 2 nuts and starter assembly.


v.
A357295

for Manual Transmission:

w/o Urea SCR System:

Remove the 4 bolts, 3 nuts, clip, and then disconnect the clutch release cylinder assembly.


vi.
A357294

for Manual Transmission:

Remove the bolt, nut and starter assembly.