Home › Power Source / Network › 1GD-FTV (BATTERY / CHARGING) › GENERATOR (for 100 A Type) › from 2020.08
RM27T0E _57 Power Source / Network _053727 1GD-FTV BATTERY / CHARGING _0261026 GENERATOR(for 100 A Type) A

1GD-FTV BATTERY / CHARGING  GENERATOR(for 100 A Type)  INSTALLATION  


PROCEDURE

Hide 27060 1.INSTALL GENERATOR ASSEMBLY

a.

Install the generator bracket to the generator assembly with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


b.

Install the generator assembly with the 2 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


c.

Attach the clamp and connect the wire harness to the generator bracket.


d.

Connect the wire harness to the generator assembly with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


e.

Connect the wire harness to terminal B with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


f.

Install the terminal cap.


g.

Connect the connector to the generator assembly.


Hide 16361A 2.INSTALL FAN AND GENERATOR V BELT

Hide 17342F 3.INSTALL NO. 2 INTERCOOLER AIR HOSE (w/o Urea SCR System)

Hide 12601B 4.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 74431 5.INSTALL BATTERY TRAY

Hide 28800 6.INSTALL BATTERY

Hide 74481 7.INSTALL BATTERY HOLD DOWN CLAMP

a.

Install the battery hold down clamp with the 2 nuts and 2 battery clamp bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 9. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART