Home › Engine / Hybrid System › 5L-E (COOLING) › WATER PUMP › from 2020.08
RM27T0E _51 Engine / Hybrid System _053683 5L-E COOLING _0260668 WATER PUMP A

5L-E COOLING  WATER PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine water pump assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) battery terminal Correction of steering angle neutral point Multi-terrain monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane departure alert system Drive the vehicle straight ahead at 40 km/h (25 mph) or more for 10 seconds or more. (Click here)
Pre-collision system
Lighting system (EXT) (for LED Headlight)
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Vehicle stability control system (for Hydraulic brake booster) Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds. (Click here)


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 28800 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 53292A 4.REMOVE UPPER RADIATOR SUPPORT SEAL

Hide 51405A 6.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 51450 7.REMOVE REAR ENGINE UNDER COVER ASSEMBLY

Hide 16571C 9.REMOVE NO. 1 RADIATOR HOSE

a.
A218411

Detach the clamp and remove the No. 1 radiator hose.


b.
A218417

Remove the 2 nuts and hose clamp.


Hide 16572D 10.REMOVE NO. 2 RADIATOR HOSE

A218413

Hide 16470 11.REMOVE RADIATOR RESERVOIR

a.
A224937

Disconnect the reservoir hose from the upper side of the radiator tank.


b.

Remove the 3 bolts and radiator reservoir.


Hide 16711 12.REMOVE FAN SHROUD

a.
A218410

Loosen the 4 nuts holding the fluid coupling fan.


b.

Remove the vane pump V belt and the fan and generator V belt (See page Engine / Hybrid System>5L-E (ENGINE MECHANICAL)>DRIVE BELT>REMOVAL).


c.
A224938

Remove the 2 bolts holding the fan shroud.


d.

Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.

NOTICE:

Be careful not to damage the radiator core.



e.

Remove the fan pulley from the water pump.


Hide 88440D 14.REMOVE NO. 2 IDLE PULLEY ASSEMBLY

Hide 13568 15.REMOVE TIMING BELT

Hide 16100 16.REMOVE WATER PUMP ASSEMBLY

a.
A218416

Remove the 6 bolts and tension spring bracket.


b.

Remove the water pump and gasket.