Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for Hydraulic Brake Booster) › from 2020.08
RM27T0E _54 Brake _053713 BRAKE SYSTEM (OTHER) _0260926 BRAKE PEDAL(for Hydraulic Brake Booster) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for Hydraulic Brake Booster)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

a.

Temporarily install the reinforcement set bolt.


b.

for LHD:

i.

Install the hydraulic brake booster (See page Brake>BRAKE SYSTEM (OTHER)>HYDRAULIC BRAKE BOOSTER(for LHD)>INSTALLATION).



c.

for RHD:

i.

Install the hydraulic brake booster (See page Brake>BRAKE SYSTEM (OTHER)>HYDRAULIC BRAKE BOOSTER(for RHD)>INSTALLATION).



d.

Install the brake pedal support sub-assembly with the 4 nuts.

Torque:
14 N*m (145 kgf*cm, 10 ft.*lbf)


e.

Install the brake pedal support reinforcement set bolt.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


Hide 47264A 2.INSTALL PUSH ROD PIN

a.
C215915E01
0.829,1.638 1.054,1.807 0.225,0.169 10 *1

Apply a light coat of lithium soap base glycol grease to the inner surface of the hole on the brake pedal lever.

Text in Illustration
*1 Lithium soap base glycol grease


b.
C213444

Set the master cylinder push rod clevis in place, insert the push rod pin from the left side of the vehicle, and then install a new clip.


Hide 47101A 3.INSTALL BRAKE PEDAL RETURN SPRING

a.

Apply a light coat of lithium soap base glycol grease to inner surface of the hole in the brake pedal support sub-assembly.


b.

Install the brake pedal return spring to the brake pedal support sub-assembly.


Hide 84340 4.INSTALL STOP LIGHT SWITCH ASSEMBLY

a.

Install the stop light switch (See page Vehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>INSTALLATION).


b.

Connect the stop light switch connector.


Hide 73900 5.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

a.

Install the lower No. 1 instrument panel airbag assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>KNEE AIRBAG ASSEMBLY>INSTALLATION).


Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 8.FILL RESERVOIR WITH BRAKE FLUID

Hide 10.CHECK FLUID LEVEL IN RESERVOIR

Hide 11.CHECK FOR BRAKE FLUID LEAK FROM CLUTCH LINE

Hide 12.CHECK AND ADJUST BRAKE PEDAL

Hide 13. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART