Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for Vacuum Brake Booster) › from 2020.08
RM27T0E _54 Brake _053713 BRAKE SYSTEM (OTHER) _0260925 BRAKE PEDAL(for Vacuum Brake Booster) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for Vacuum Brake Booster)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 73900 3.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

a.

Remove the lower No. 1 instrument panel airbag assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>KNEE AIRBAG ASSEMBLY>REMOVAL).


Hide 47101A 4.REMOVE BRAKE PEDAL RETURN SPRING

Hide 47264A 5.REMOVE PUSH ROD PIN

a.

Remove the clip and push rod pin from the brake pedal.


Hide 84340 6.REMOVE STOP LIGHT SWITCH ASSEMBLY

a.

Disconnect the stop light switch connector.


b.

Remove the stop light switch assembly (See page Vehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>REMOVAL).


Hide 84341 7.DISCONNECT BRAKE PEDAL LOAD SENSING SWITCH

a.
C215262E01
0.074,0.036 0.769,0.207 0.696,0.172 12 for LHD:

Disconnect the brake pedal load sensing switch connector.


Hide 8.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.
C215922

Remove the brake pedal support reinforcement set bolt.


b.

for LHD:

i.

Remove the brake master cylinder sub-assembly (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE MASTER CYLINDER>REMOVAL).


ii.

Remove the brake booster assembly (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER>REMOVAL).



c.

for RHD:

i.

Remove the brake actuator assembly (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR>REMOVAL).


ii.

Remove the brake master cylinder sub-assembly (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE MASTER CYLINDER>REMOVAL).


iii.

Remove the brake booster assembly (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER>REMOVAL).



d.
C214646

Remove the 4 nuts and brake pedal support assembly.