Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.
1.DRAIN BRAKE FLUID
Wash off brake fluid immediately if it comes in contact with any painted surface.
2.REMOVE AIR CLEANER CASE (for 2TR-FE RHD)
Remove the air cleaner case (See page Engine / Hybrid System>2TR-FE (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL).
17700
3.REMOVE AIR CLEANER CASE ASSEMBLY (for 5L-E RHD)
Remove the air cleaner case assembly (See page Engine / Hybrid System>5L-E (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL).
4.REMOVE CLUTCH TUBE (for Manual Transmission)
Slide the clip and disconnect the clutch tube.
47201
5.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
Remove the brake master cylinder sub-assembly (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE MASTER CYLINDER>REMOVAL).
47101A
6.REMOVE BRAKE PEDAL RETURN SPRING
47264A
7.REMOVE PUSH ROD PIN
47264D
8.DISCONNECT BRAKE MASTER CYLINDER PUSH ROD CLEVIS
Loosen the brake master cylinder push rod clevis lock nut.
Disconnect the push rod clevis.
9.DISCONNECT VACUUM HOSE
Slide the clip and disconnect the vacuum hose.
| *A | for LHD |
| *B | for RHD |
44730
10.REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY
Remove the vacuum check valve assembly from the brake booster assembly.
44696
11.REMOVE CHECK VALVE GROMMET
Remove the check valve grommet from the brake booster assembly.
31410
12.REMOVE CLUTCH MASTER CYLINDER ASSEMBLY (for RHD)
Remove the clutch master cylinder assembly (See page Drivetrain>CLUTCH>CLUTCH MASTER CYLINDER (for RHD)>REMOVAL).
47371B
13.DISCONNECT BRAKE TUBE CLAMP (for RHD)
Remove the brake tube from the 2 brake tube clamps.
Disconnect the 2 brake tube clamps from the body.
44610
14.REMOVE BRAKE BOOSTER ASSEMBLY
Remove the 4 nuts and brake booster assembly from the body.
Do not damage the brake lines.
44785
15.REMOVE BRAKE BOOSTER GASKET
Remove the brake booster gasket from the brake booster assembly.
47264D
16.REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS
Loosen the lock nut and remove the brake master cylinder push rod clevis and lock nut from the brake booster assembly.