Home › Suspension › SUSPENSION CONTROL › HEIGHT CONTROL SENSOR › from 2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260876 HEIGHT CONTROL SENSOR A

SUSPENSION CONTROL  HEIGHT CONTROL SENSOR  INSTALLATION  


PROCEDURE

Hide 89408D 1.INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

a.
C212873E02
3.125,2.188 3.125,3.052 3.125,3.052 2.479,3.052 true 2.948,2.229 2.948,3.042 true 2.313,2.958 2.469,3.104 0.156,0.146 10 false *1

Install the height control sensor with the 2 bolts.

Text in Illustration
*1 Matchmark

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)

NOTICE:

Replace the rear height control sensor sub-assembly with a new one if it is dropped.



b.

Align the matchmarks on the link and bracket.


c.

Connect the sensor link with the nut.

Torque:
5.6 N*m (57 kgf*cm, 50 in.*lbf)


d.

Connect the connector, and then attach the connector.


e.

Attach the clamp.


Hide 2.INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 6. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART