Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM › from 2021.06
RM27T0E _56 Audio / Visual / Telematics _056796 TELEMATICS _0277431 TELEMATICS SYSTEM C

TELEMATICS  TELEMATICS SYSTEM  B153711  Telephone Sub Antenna Circuit Short to Ground  B153713  Telephone Sub Antenna Circuit Open  


DESCRIPTION

These DTCs are stored when a malfunction occurs in the telephone sub antenna circuit.

DTC No. Detection Item DTC Detection Condition Trouble Area
B153711 Telephone Sub Antenna Circuit Short to Ground Telephone antenna (sub) impedance (Ω) is lower than the malfunction threshold for 10 seconds or more when the ignition switch is ON.
(Short circuit)
·

Telephone transceiver assembly

·

Navigation antenna assembly

·

Antenna cord sub-assembly

·

Telephone antenna cord sub-assembly (I/P)


B153713 Telephone Sub Antenna Circuit Open Telephone antenna (sub) impedance (Ω) is higher than the malfunction threshold for 10 seconds or more when the ignition switch is ON.
(Open circuit)
·

Telephone transceiver assembly

·

Navigation antenna assembly

·

Antenna cord sub-assembly

·

Telephone antenna cord sub-assembly (I/P)



WIRING DIAGRAM

E467075E02
1.479,2.146 2.688,2.563 1.208,0.417 10 false Navigation Antenna Assembly 4.292,2.406 5.531,3.021 1.24,0.615 10 false Telephone Antenna Cord Sub-assembly (I/P) 5.719,2.365 7.156,2.708 1.438,0.344 10 false Telephone Transceiver Assembly 5.875,1 6.479,1.354 0.604,0.354 10 false TELS2 5.51,0.781 5.625,0.948 0.115,0.167 10 false 1 5.479,1.458 5.677,1.625 0.198,0.167 10 false 1a 4.177,0.76 4.292,0.927 0.115,0.167 10 false 1 5.385,1.01 5.875,1.24 0.49,0.229 10 false H110 5.385,1.688 5.875,1.917 0.49,0.229 10 false H110 4.135,1.448 4.333,1.615 0.198,0.167 10 false 1a 2.823,0.781 3.406,1 0.583,0.219 10 false 4 2.781,1.438 3.365,1.646 0.583,0.208 10 false 4a 3.104,2.396 4.021,2.76 0.917,0.365 10 false Antenna Cord Sub-assembly 2.823,1.031 3.313,1.26 0.49,0.229 10 false A 2.823,1.698 3.313,1.927 0.49,0.229 10 false A 4.052,1.01 4.542,1.24 0.49,0.229 10 false H107 4.063,1.698 4.552,1.927 0.49,0.229 10 false H107 3.51,1.021 4.115,1.375 0.604,0.354 10 false TELS1

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM>PRECAUTION

·

When replacing the telephone transceiver assembly, make sure to replace it with a new one.



PROCEDURE

1.CHECK DTC
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON and wait for 10 seconds or more.


d.

Turn the GTS on.


e.

Check for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM>DTC CHECK / CLEAR

OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

2.INSPECT NAVIGATION ANTENNA ASSEMBLY
2.INSPECT NAVIGATION ANTENNA ASSEMBLY
a.
E356744C24
1.375,1.177 1.417,0.833 true 1.438,0.802 1.302,0.323 true 0.135,0.146 0.448,0.344 0.313,0.198 10 false *a 1.198,1.156 1.406,1.385 0.208,0.229 10 false 4a 1.188,0.156 1.396,0.385 0.208,0.229 10 false 4
*a Component without harness connected
(Navigation Antenna Assembly)


Remove the navigation antenna assembly.

w/ Heated Windshield Defroster System: Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION ANTENNA (w/ Heated Windshield Defroster System)>REMOVAL

w/o Heated Windshield Defroster System: Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION ANTENNA (w/o Heated Windshield Defroster System)>REMOVAL


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 - 4a Always 9 to 11 kΩ



Result:
Proceed to
OK
NG



OK

3.INSPECT ANTENNA CORD SUB-ASSEMBLY

NG

3.INSPECT ANTENNA CORD SUB-ASSEMBLY
a.
E467076C02
0.521,0.646 0.885,0.917 0.365,0.271 0.438,2.271 0.885,2.573 0.448,0.302 2.063,0.677 2.5,0.333 2.5,0.333 2.698,0.333 true 1.865,2.813 2.24,3.073 2.24,3.073 2.438,3.073 true 1.76,2.698 2.198,2.354 2.198,2.354 2.396,2.354 true 0.125,0.135 0.438,0.333 0.313,0.198 10 false *a 2.771,0.25 3.083,0.448 0.313,0.198 10 false 4a 2.479,2.979 2.792,3.177 0.313,0.198 10 false 1a 0.656,0.698 0.969,0.896 0.313,0.198 10 false A 0.51,2.333 0.99,2.583 0.479,0.25 10 false H107 0.167,1.792 0.479,1.99 0.313,0.198 10 false *b 2.438,2.281 3.063,2.583 0.625,0.302 10 false TELS1
*a Front view of wire harness connector
(to Navigation Antenna Assembly)
*b Front view of wire harness connector
(to Telephone Antenna Cord Sub-assembly [I/P])


Disconnect the antenna connector from the navigation antenna assembly.


b.

Disconnect the antenna connector from the telephone antenna cord sub-assembly (I/P).


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A-4 - H107-1 (TELS1) Always Below 1 Ω
A-4a - H107-1a Always Below 1 Ω
A-4 - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.INSPECT TELEPHONE ANTENNA CORD SUB-ASSEMBLY (I/P)

NG

4.INSPECT TELEPHONE ANTENNA CORD SUB-ASSEMBLY (I/P)
a.
E467077C02
0.542,2.521 1.021,2.792 0.479,0.271 0.458,0.646 0.938,0.917 0.479,0.271 1.833,0.969 2.271,0.625 2.271,0.625 2.469,0.625 true 1.833,2.854 2.24,3.073 2.24,3.073 2.438,3.073 true 1.625,2.813 1.167,3.146 1.167,3.146 1.01,3.146 true 1.677,0.979 1.104,1.5 1.104,1.5 0.948,1.5 true 0.125,0.135 0.438,0.333 0.313,0.198 10 false *a 2.521,0.542 2.833,0.74 0.313,0.198 10 false 1a 2.479,2.979 2.792,3.177 0.313,0.198 10 false 1a 0.552,0.698 0.927,0.917 0.375,0.219 10 false H107 0.615,2.563 1.094,2.813 0.479,0.25 10 false H110 0.167,1.792 0.479,1.99 0.313,0.198 10 false *b 0.573,3.063 1.042,3.25 0.469,0.188 10 false TELS2 0.49,1.427 0.958,1.615 0.469,0.188 10 false TELS1
*a Front view of wire harness connector
(to Antenna Cord Sub-assembly)
*b Front view of wire harness connector
(to Telephone Transceiver Assembly)


Disconnect the antenna connector from the antenna cord sub-assembly.


b.

Disconnect the antenna connector from the telephone transceiver assembly.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H107-1(TELS1) - H110-1 (TELS2) Always Below 1 Ω
H107-1a - H110-1a Always Below 1 Ω
H107-1(TELS1) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

5.CHECK NAVIGATION ANTENNA ASSEMBLY

NG

REPLACE TELEPHONE ANTENNA CORD SUB-ASSEMBLY (I/P)

5.CHECK NAVIGATION ANTENNA ASSEMBLY


c.

Recheck for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM>DTC CHECK / CLEAR

OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END (NAVIGATION ANTENNA ASSEMBLY IS DEFECTIVE)

NG

6.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
6.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
a.

Replace the telephone transceiver assembly with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


Result:
Proceed to
NEXT



NEXT