Wear protective gloves. Sharp areas on the parts may injure your hands.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
73580A
1.INSTALL REAR NO. 2 SEAT INNER BELT ASSEMBLY LH
Using a T45 "TORX" socket wrench, install the inner belt assembly with the bolt.
w/ Seat Belt Warning System:
Attach the clamp and connect the connector.
79384
2.INSTALL REAR SEAT LEG COVER LH (w/ Seat Belt Warning System)
79202
3.INSTALL NO. 2 SEAT CUSHION FRAME SUB-ASSEMBLY LH (w/ Seat Belt Warning System)
71834C
4.INSTALL REAR NO. 3 SEAT OUTER RECLINING COVER LH (w/ Seat Belt Warning System)
71834C
5.INSTALL REAR NO. 3 SEAT INNER RECLINING COVER LH (w/ Seat Belt Warning System)
6.INSTALL SEATBACK COVER WITH PAD (w/ Seat Belt Warning System)
71865
7.INSTALL REAR SEAT NO. 1 COVER BEZEL (w/ Seat Belt Warning System)
72635B
8.INSTALL REAR SEATBACK LOCK HOOK (w/ Seat Belt Warning System)
71702C
9.INSTALL REAR SEATBACK BOARD SUB-ASSEMBLY LH (w/ Seat Belt Warning System)
66310F
10.INSTALL ROPE HOOK ASSEMBLY (w/ Seat Belt Warning System, Seatback Hook)
72152
11.INSTALL LOWER SEAT TRACK RAIL LH (w/ Seat Belt Warning System, Seatback Rail)
79384A
12.INSTALL REAR SEAT NO. 3 LEG COVER LH (w/ Seat Belt Warning System)
71827B
13.INSTALL REAR SEAT NO. 2 CUSHION MOULDING (w/ Seat Belt Warning System)
14.INSTALL SEAT CUSHION COVER WITH PAD (w/ Seat Belt Warning System)
71827B
15.INSTALL REAR SEAT NO. 1 CUSHION MOULDING (w/ Seat Belt Warning System)
71693
16.INSTALL REAR SEAT CUSHION LOWER HINGE COVER RH
71693
17.INSTALL REAR SEAT CUSHION LOWER HINGE COVER LH (w/ Seat Belt Warning System)
18.INSTALL REAR NO. 2 SEAT ASSEMBLY LH
Install the rear No. 2 seat assembly LH (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Power Seat Type LH Side)>INSTALLATION).
19.PERFORM INITIALIZATION
Under either of the following conditions, perform initialization (initial position memorization) of the fold seat control ECU (See page Vehicle Interior>SEAT>REAR POWER SEAT CONTROL SYSTEM>INITIALIZATION).
The fold seat control ECU is replaced with a new one.
Initialization (initial position reset) of the fold seat control ECU is performed.
Under any of the following conditions, perform initialization (initial position reset and initial position memorization) of the fold seat control ECU (See page Vehicle Interior>SEAT>REAR POWER SEAT CONTROL SYSTEM>INITIALIZATION).
The fold seat control ECU is exchanged with one from another vehicle.
The seatback frame and seat leg are inspected.
The seat is disassembled and the positions of the seatback and seat cushion change with respect to one another.
The seatback frame or seat leg is replaced.
The cable is disconnected from the battery while the seatback or seat cushion is operating.
20.CHECK REAR NO. 2 SEAT
Check the power seat operation (See page Vehicle Interior>SEAT>REAR POWER SEAT CONTROL SYSTEM>OPERATION CHECK).
21.CHECK SEAT BELT WARNING SYSTEM (w/ Seat Belt Warning System)