Home › Suspension › SUSPENSION CONTROL › KINETIC DYNAMIC SUSPENSION SYSTEM › from 2021.06
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260886 KINETIC DYNAMIC SUSPENSION SYSTEM C

SUSPENSION CONTROL  KINETIC DYNAMIC SUSPENSION SYSTEM  C1879  Zero Point Calibration Acceleration Sensor Adjustment Undone  


DESCRIPTION

The stabilizer control ECU receives the yaw rate and acceleration sensor zero point information from the skid control ECU via CAN communication.

DTC Code DTC Detection Condition Trouble Area
C1879 A signal indicating that the yaw rate and acceleration sensor zero point calibration has not been performed is continuously received from the skid control ECU for 5 seconds.
·

Brake control system (Yaw rate and acceleration sensor zero point calibration)

·

Stabilizer control ECU



CAUTION / NOTICE / HINT

HINT:

When this DTC is output, obtain the calibration value of the yaw rate and acceleration sensor zero point first.


PROCEDURE

1.PERFORM ZERO POINT CALIBRATION

NEXT

2.RECONFIRM DTC
2.RECONFIRM DTC

b.

Check for DTCs (See page Suspension>SUSPENSION CONTROL>KINETIC DYNAMIC SUSPENSION SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is output A
DTC is not output B



A

REPLACE STABILIZER CONTROL ECU

B

END