2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Illumination for Panel Switch does not Come on with Tail Switch ON

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

INSPECTION PROCEDURE


1. CHECK VEHICLE SIGNAL (OPERATION CHECK)
E176538
  1. Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (Click here).

  1. Cover the automatic light control sensor on the instrument panel with a cloth.

  1. Set the instrument panel light control to less than the maximum (to activate the dimmer function that works when the light control switch is in the TAIL position).

  1. Check that the display changes between ON and OFF according to the light control switch operation.

    OK:
    Light Control Switch Condition
    Display Condition
    TAIL or HEAD
    ON
    OFF
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY (Click here)


← U0073 Control Module Communication Bus Off (+ U0155, U0164, U1110) (Sep 2011 – Dec 2011)Display does not Dim when Light Control Switch is Turned ON (Sep 2011 – Dec 2011) →