2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Display does not Dim when Light Control Switch is Turned ON

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

INSPECTION PROCEDURE


1. CHECK IMAGE QUALITY SETTING

  1. E176539E03
    Enter the display adjustment screen by pressing the "DISP" switch.

  1. Turn the light control switch to the tail position.

  1. Check if "Day Mode" on the display adjustment is on.

    OK:
    "Day Mode" is on.



NG
Go to step 2
OK

TURN "Day Mode" SETTING OFF

2. CHECK VEHICLE SIGNAL (OPERATION CHECK)

  1. E176538
    Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (Click here).

  1. Cover the automatic light control sensor on the instrument panel with a cloth.

  1. Set the instrument panel light control to less than the maximum (to activate the dimmer function that works when the light control switch is in the TAIL position).

  1. Check that the display changes between ON and OFF according to the light control switch operation.

    OK:
    Light Control Switch Condition
    Display Condition
    TAIL or HEAD
    ON
    OFF
    OFF

    HINT:
    The display is updated once per second. It is normal for the display to lag behind the actual switch operation.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY (Click here)


← Illumination for Panel Switch does not Come on with Tail Switch ON (Sep 2011 – Dec 2011)Panel Switches do not Function (Sep 2011 – Dec 2011) →