2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Voice is not Recognized

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

INSPECTION PROCEDURE


1. CHECK NAVIGATION SETTING

  1. E181035E01
    Display the "Voice Settings" screen.

  1. Check that "Voice Recognition Guidance" is not "Off".

    OK:
    "Voice Recognition Guidance" is not "Off".

Text in Illustration 
*1
Example:


NG
TURN VOICE RECOGNITION GUIDANCE "On"
OK


2. CHECK MICROPHONE AND VOICE RECOGNITION (OPERATION CHECK)

  1. E187218E01
    Enter the "Microphone & Voice Recognition Check" screen. Refer to Check Mic & Voice Recognition in Operation Check (Click here).

  1. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Push the recording switch and perform voice recording.

    HINT:
    Voice can be recorded up to 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.

Text in Illustration 
*1
Microphone Input Level Meter
*2
Recording Switch
*3
Stop Switch
*4
Play Switch
*5
Recording Indicator


NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK


3. REPLACE HARD DISK DRIVE
  1. Replace the hard disk drive (Click here).

  1. Check that voice recognition is normal.

OK:
Voice can be recognized normally.



NG
REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY (Click here)
OK

END


← Voice Recognition Difficulty (Sep 2011 – Dec 2011)Cellular Phone Registration Failure, Phone Directory Transfer Failure (Sep 2011 – Dec 2011) →