2011-2013 Land Cruiser · Service Manual Vehicle Interior

B2282 Vehicle Speed Signal Malfunction

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Also covers:

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The main body ECU and the combination meter are connected with a cable and the CAN communication line. DTC B2282 is stored when signals, transmitted through the cable and communication line, do not match.
DTC Code
Detection Condition
Trouble Area
B2282
When the following conditions are met:
  1. Signals between the main body ECU and combination meter are inconsistent.
  1. A malfunction is detected in the circuit between the vehicle speed sensor and combination meter.
  1. Main body ECU
  1. Combination meter assembly
  1. Harness or connector
The skid control ECU converts signals from the speed sensor into 4-pulse signals and sends them to the combination meter. After these signals are converted into a more precise rectangular waveform by the waveform shaping circuit inside the combination meter, they are then transmitted to the main body ECU. The main body ECU determines the vehicle speed based on the frequencies of these pulse signals.
DTC Code
Detection Condition
Trouble Area
B2283
When both of the conditions below are met:
  1. Vehicle speed decreases significantly.
  1. Vehicle speed does not correspond with engine speed.
  1. Main body ECU
  1. Combination meter assembly
  1. Speed sensor
  1. Skid control ECU
  1. Harness or connector
C166257E04

WIRING DIAGRAM

C165199E06

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED SIGNAL)
  1. Use the Data List to check if the vehicle speed signal is functioning properly.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Vehicle Speed Signal
    Vehicle speed signal/STOP or RUN
    STOP: Vehicle stopped
    RUN: Vehicle running
    -
    Result 
    Result
    Proceed to
    Display on the intelligent tester does not change according to vehicle condition
    A
    Display on the intelligent tester changes according to vehicle condition
    B



B
REPLACE MAIN BODY ECU
A


2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - COMBINATION METER)
A175402E01
  1. Disconnect the E3 main body ECU connector.

  1. Disconnect the E7 combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E3-9 (SPD) - E7-10 (+S)
    Always
    Below 1 Ω
    E3-9 (SPD) or E7-10 (+S) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. REPLACE MAIN BODY ECU
  1. Temporarily replace the main body ECU with a new or normally functioning one.

  1. Check whether DTC B2282 and B2283 are output.

    Result 
    Result
    Proceed to
    DTC not output
    A
    DTC output (w/ Multi-information Display)
    B
    DTC output (w/o Multi-information Display)
    C



B
REPLACE COMBINATION METER (Click here)

C
REPLACE COMBINATION METER (Click here)
A

END


← B2281 "P" Signal Malfunction (from Jan 2012)B2282 Vehicle Speed Signal Malfunction (+ B2283) (from Jan 2012) →