B2281 "P" Signal Malfunction
Diagnostic trouble codes · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This DTC is stored when there is an abnormal circuit between the main body ECU and the shift lock control ECU.| DTC Code |
Detection Condition |
Trouble Area |
| B2281 |
Communication or the communication line is abnormal between the main body ECU and shift lock control ECU. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (SHIFT P SIGNAL) |
Use the Data List to check if the shift position signal is functioning properly.
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Shift P Signal
Shift P position signal/ON or OFF
ON: Shift lever in P
OFF: Shift lever not in P
-
Result Result
Proceed to
Display on the intelligent tester does not change according to shift lever operation
A
Display on the intelligent tester changes according to shift lever operation
B
|
|
||||
| A | |
| 2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SHIFT LOCK CONTROL ECU AND BODY GROUND) |


Disconnect the E4 main body ECU connector.
Disconnect the E51 shift lock control ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E4-2 (P) - E51-11 (P2)
Always
Below 1 Ω
E51-3 (E) - Body ground
Always
Below 1 Ω
E4-2 (P) or E51-11 (P2) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 3. INSPECT SHIFT LOCK CONTROL ECU |
Check the signal waveform according to the condition(s) in the table below.



Reference Terminal No. (Symbol)
Tool Setting
Condition
E51-11 (P2) - E51-3 (E)
2 V/DIV., 20 msec./DIV.
Shift lever in P
- OK:
- The waveform is similar to that shown in the illustration.
Result Result
Proceed to
OK
A
NG
for 1GR-FE
B
for 1VD-FTV, 3UR-FE, 1UR-FE
C
|
|
||||
|
|
||||
| A | ||
| ||
