HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
- HINT:
- Use the following procedures to troubleshoot the power tilt and telescopic steering column system.
- *: Use the intelligent tester.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| NEXT |
|
 |
|
|
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| NEXT |
|
 |
|
|
| 3.CHECK CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning normally.
Result
Result
|
Proceed to
|
CAN DTC is not output
|
A
|
for LHD: CAN DTC is output
|
B
|
for RHD: CAN DTC is output
|
C
|
Check for DTCs (Click here).
Clear the DTCs (Click here).
Recheck for DTCs (Click here).
Result
Result
|
Proceed to
|
DTC is not output
|
A
|
DTC is output
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
Result
Result
|
Proceed to
|
Fault is not listed in problem symptoms table
|
A
|
Fault is listed in problem symptoms table
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Terminals of ECU (Click here)
Data List/Active Test (Click here)
| NEXT |
|
 |
|
|
| NEXT |
|
 |
|
|
| NEXT |
|
 |
|
|