B2278 Engine Switch Circuit Malfunction
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This DTC is stored when: 1) a malfunction is detected between the main body ECU and the engine switch; or 2) either of the switches inside the engine switch is malfunctioning.| DTC Code |
Detection Condition |
Trouble Area |
| B2278 |
Communication is abnormal between the main body ECU and engine switch or the engine switch is defective. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (START SWITCH 1, 2) |
Use the Data List to check if the engine switch is functioning properly.
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Start Switch 1
Start Switch 1/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
Start Switch 2
Start Switch 2/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
- OK:
- When the engine switch is turned on (IG), ON is displayed on the intelligent tester.
|
|
||||
| OK | |
| 2. CHECK WHETHER DTC OUTPUT RECURS |
Clear the DTCs (Click here).
Turn the engine switch on (IG), and check whether DTC B2278 is output.
Result Result
Proceed to
No DTC output
A
DTC B2278 output
B
|
|
||||
| A | ||
| ||
| 3. INSPECT ENGINE SWITCH |
![]() ![]() |
Disconnect the E18 engine switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
7 (SS1) - 5 (GND)
Pushed
Below 1 Ω
2 (SS2) - 5 (GND)
Pushed
Below 1 Ω
7 (SS1) - 5 (GND)
Not pushed
10 kΩ or higher
2 (SS2) - 5 (GND)
Not pushed
10 kΩ or higher
Result Result
Proceed to
Within specified range
A
Outside specified range (for 1GR-FE)
B
Outside specified range (for 2UZ-FE)
C
Outside specified range (for 3UR-FE)
D
Outside specified range (for 1VD-FTV)
E
|
|
||||
|
|
||||
|
|
||||
|
|
||||
| A | |
| 4. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ENGINE SWITCH AND BODY GROUND) |


Disconnect the E1 main body ECU connector.
Disconnect the E18 engine switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E1-17 (SSW1) - E18-7 (SS1)
Always
Below 1 Ω
E1-16 (SSW2) - E18-2 (SS2)
Always
Below 1 Ω
E18-5 (GND) - Body ground
Always
Below 1 Ω
E1-17 (SSW1) or E18-7 (SS1) - Body ground
Always
10 kΩ or higher
E1-16 (SSW2) or E18-2 (SS2) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||

