B2602 Key Unlock Warning Switch Circuit Malfunction
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Also covers:
- B2606 Key Code Confirm Signal Malfunction
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
A key code confirmation signal (ON or OFF) is sent from the main body ECU to the multiplex tilt and telescopic ECU via the communication bus.The multiplex tilt and telescopic ECU uses this signal to operate the auto away/return function.
| DTC Code |
Detection Condition |
Trouble Area |
| B2602 |
Both of the following conditions continue:
|
|
| B2606 |
IG signals and/or key code confirmation signals are not received correctly. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK OTHER DTC OUTPUT |
- HINT:
- The power tilt and power telescopic steering column system uses the CAN communication system, so check its diagnostic system before proceeding to troubleshooting.
Check if DTC B2621 is output.
Result DTC Condition
Proceed to
B2621 is not output
A
B2621 is output
B
- HINT:
- If DTC B2621 is output, perform troubleshooting for B2621 first.
- DTC B2621 indicates a communication interruption for the power tilt and power telescopic steering column system.
- If DTC B2621 is output, perform troubleshooting for B2621 first.
|
|
||||
| A | |
| 2. READ VALUE USING INTELLIGENT TESTER (COMMUNICATION STATE OF ENGINE SWITCH AND KEY CODE) |
Use the Data List to check if the communication of the key code and the engine switch are functioning properly.
Tilt & Telescopic Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
IG Switch (CAN)
Communication state of engine switch/ON or OFF
ON: Communication normal
OFF: Communication interrupted
-
Key Code Confirm (CAN)
Communication state of key code confirmation signal/ON or OFF
ON: Communication normal
OFF: Communication interrupted
-
- OK:
- "ON" is displayed.
|
|
||||
| OK | |
| 3. RECONFIRM DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
- OK:
- DTC B2602 and/or B2606 is not output.
|
|
||||
| OK | ||
| ||
