2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

NOTICE:
  1. When replacing an injector (including interchanging injectors between cylinders) or common rail, replace the corresponding injection pipes with new ones.
  2. w/DPF
    When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines.


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE INTERCOOLER ASSEMBLY (w/ Intercooler)
(Click here)

4. REMOVE INJECTION PIPES
(Click here)

5. REMOVE NO. 1 GLOW PLUG CONNECTOR
  1. Remove the 2 screw grommets and 2 nuts, and disconnect the 2 wire harnesses.

  1. A269587E01
    Remove the 8 screw grommets, 8 nuts and 2 glow plug connectors.
    Text in Illustration 
    *a
    RH
    *b
    LH


6. REMOVE GLOW PLUG ASSEMBLY

  1. A269588E01
    Using a 10 mm deep socket wrench, remove the 8 glow plugs.
    Text in Illustration 
    *a
    RH
    *b
    LH

    HINT:
    Before removing the glow plugs, thoroughly clean off all dirt, sand, etc.

← REMOVAL (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →